Sharp CP-SR421 User Manual Page 112

  • Download
  • Add to my manuals
  • Print
  • Page
    / 404
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 111
5. PARAMETERS
5 - 15
No. Symbol Name and function
Initial
value
(unit)
Setting
range
PA14
POL
Rotation direction selection/travel direction selection
This is used to select a rotation direction or travel direction.
0 0 to 1
Servo motor rotation direction/linear servo motor travel
direction
Setting
value
Positioning address
increase
Positioning address
decrease
0 CCW or positive direction CW or negative direction
1 CW or negative direction CCW or positive direction
The following shows the servo motor rotation directions.
ᱜォ(CCW)
ㅒォ(CW)
The positive/negative directions of the linear servo motor are as follows.
ੑᰴ஥
৻ᰴ஥
ᱜᣇะ
⽶ᣇะ
LM-H3/LM-F series
⽶ᣇะ
ᱜᣇะ
ੑᰴ஥
৻ᰴ஥
LM-U2 series
⽶ᣇะ
ᱜᣇะ
࠹࡯ࡉ࡞
৻ᰴ஥
ੑᰴ஥
LM-K2 series
PA15
ENR
Encoder output pulses
Set the encoder output pulses from the servo amplifier by using the number of output pulses
per revolution, dividing ratio, or electronic gear ratio. (after multiplication by 4)
To set a numerator of the electronic gear, select "A-phase/B-phase pulse electronic gear
setting (_ _ 3 _)" of "Encoder output pulse setting selection" in [Pr. PC03].
The maximum output frequency is 4.6 Mpps. Set the parameter within this range.
4000
[pulse/
rev]
1 to
65535
PA16
ENR2
Encoder output pulses 2
Set a denominator of the electronic gear for the A/B-phase pulse output.
To set a denominator of the electronic gear, select " A-phase/B-phase pulse electronic gear
setting (_ _ 3 _)" of "Encoder output pulse setting selection" in [Pr. PC03].
1 1 to
65535
Forward rotation (CCW)
Reverse rotation (CW)
Negative
direction
Negative
direction
Negative direction
Positive
direction
Positive
direction
Positive
direction
Primary side
Secondary
side
Secondary
side
Primary side
Primary side
Negative
direction
Table
Page view 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 403 404

Comments to this Manuals

No comments