Sharp FO-6700 Service Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 192
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
FO-6700U
FO-67DL
1 – 4
1. Open the print compartment cover.
2. Remove the four screws that secure the rear
cover, and then remove the rear cover.
3. Remove the two screws that secure the side
plate, and then remove the side plate.
4. Disconnect the cable connector as shown.
Remove the seven screws that secure the large
plate, and then remove the large plate.
5. Insert the bottom edge of the line board into
the slots as shown and then secure the top of
the board with two screws. Connect the cable.
Use the plastic cable band to bind the cables
together as shown at right.
6. Replace the large plate and secure it with the
seven screws.
Be sure to insert the top right screw through
the wire ring connector before securing.
Reconnect the cable.
The FO-67DL is an option for the Sharp FO-6700
Important!
The following procedure is to be performed by qualified service technicians only.
Be sure to turn off the power, unplug the power cord, unplug the telephone line, and
unplug any extension telephone connected to the unit before proceeding.
Side plate
[6] Instructions for installing the FO-67DL dual line kit
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 191 192

Comments to this Manuals

No comments