Sharp FO-6700 Service Manual download pdf (Page 45)

FO-6700U

FO-67DL

[4] Error code table

1. Communication error code table

G3 Transmission

Code Final received signal Error Condition (Receiver side)

0 Incomplete signal frame Cannot recognize bit stream after flag

1 NSF, DIS Cannot recognize DCS signal by echo etc.

Cannot recognize NSS signal (FIF code etc)

2 CFR Disconnects line during reception (carrier missing etc)

3 FTT Disconnects line by fallback

4 MCF Disconnects line during reception of multi page

Cannot recognize NSS, DCS signal in the case of mode change

5 PIP or PIN The line is hung up without replying to telephone request from the receiving party.

6 RTN or RTP Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.

7 No signal or DCN No response on receiver side or DCN signal received* (transmitter side)

8 − Owing to error in some page the error could not be corrected although the specified number of

error retransmission was attempted.

11 − Error occurred after or while reception by the remote (receiving) machine was revealed to be

impossible.

12 − Error occurred just after fallback.

13 − Error occurred after a response to retransmission end command was received.

G3 Reception

2 – 37

Code Final received signal Error Condition (Receiver side)

0 Incomplete signal frame Cannot recognize bit stream after flag

1 NSS, DCS Cannot recognize CFR or FTT signal

Disconnects line during transmission (line error)

2 NSC, DTC Cannot recognize NSS signal (FIF code etc)

3 EOP Cannot recognize MCF, PIP, PIN, RTN, RTP signal

4 EOM Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change

5 MPS The line is hung up without replying to communication request.

6 PR1-Q Cannot recognize PIP, PIN signal in the case of TALK request

7 No signal or DCN No response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)

8 − Error occurred upon completion of reception of all pages.

9 − Error occurred when mode was changed or Transmission/Reception switching was performed.

10 − Error occurred during partial page or physical page reception.

11 − Error occurred after or during inquiry from the remote (transmitting) machine as to whether

reception is possible or not.

12 − Error occurred during or just after fallback.

13 − Error occurred after the retransmission end command was received.

14 − Error occurred after the voice communication command was received.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 191 192

No comments

Sharp FO-6700 Service Manual Page 45