Sharp AR-C240P Specifications download pdf (Page 118)

118 /

Table 5-1-1 Operator Alarm (6/6)

Message Cause Error Description Solutions

Open top cover

389: Paper jam

Check MP tray

390: Paper jam

Check tray *

391~395:

Paper jam

Open top cover

400: Paper

size error

Refill toner

410: Yellow

411: Magenta

412: Cyan

413: Black

Remove paper

480: Stacker

full

Set ***

490: No paper

in MP tray

(* stands for A4

B4, etc.)

Set ***

491~495: No

paper in * tray

(* stands for A4

B4, etc.)

Replace fuser

Paper in * tray

nearly empty

Disk operation

error

Jam generated in paper

path.

Paper jam during paper

feed from MT.

Paper jam detected

between cassette and

black ID.

Non-set paper (45mm

or above) detected by

printer engine.

Certain toner is almost

empty.

Paper ejection stacker

is full.

No paper in selected

cassette. cassette is

not set, or paper ran

out in cassette being

used.

Paper empty in

cassette 1, 2, 3, 4, or 5.

Fuser counter

exceeded life.

Paper near end

detected.

Cannot write in HDD.

Open front cover and check jammed paper.

Check for miss-fed paper around MT

cassette.

1) Check jammed paper between cassette

and yellow ID.

2) Check if paper entry switch is normal.

1) Is paper custom size?

2) Is paper standard size?

1) Selected toner cartridge is almost empty.

2) Check if selected toner cartridge is

normal.

1) Check if stacker is full.

2) Check if stacker full sensor is operating

properly.

1) Check if paper is empty in MT.

2) Check if paper-end sensor is operating

properly.

1) Check if paper is empty in selected

cassette.

2) Check if paper-end sensor is operating

properly.

1) Is error message displayed?

2) Was fuser unit just replaced?

Are only few papers remaining in tray?

(approx. 30 sheets or less)

Is faulty operation being applied?

Yes

Yes

No

Yes

No

Yes

Yes

No

Yes

No

Yes

No

Yes

No

Yes

No

Yes

No

Yes

No

No

Yes

Remove jammed paper.

Remove miss-fed paper and close

cover.

Check/replace MT.

Remove jammed paper.

Replace entry switch.

No treatment required.

Adjust paper size guide in cassette.

Replace paper size board (PXC PWB).

Replace with new toner kit.

Replace selected toner sensor.

Remove paper from stacker.

Replace stacker full sensor.

Set paper in MT.

Replace paper-end sensor.

Set paper in selected cassette.

Replace the corresponding paper-end

sensor.

Check fuser unit life.

Replace fuser immediately or at next

maintenance.

Refill paper.

Check paper near end sensor.

Check manual operation.

HDD abnormality. Replace HDD.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 195 196

Comments to this Manuals

No comments