Sharp FO-DC600 Instruction Manual Page 89

  • Download
  • Add to my manuals
  • Print
  • Page
    / 220
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 88
Sending an Image Using a Rapid Key
87
3. Network
Scanner
8
Press . The document is scanned and transmitted.
START/
ENTER
Sending an Image Using a Rapid Key or
Speed Dial Number
Sending an image using a Rapid Key
Use this procedure to scan a document and send the image to an E-mail, FTP,
or Desktop destination that has been stored in a Rapid Key.
Important: To use this procedure, the setup procedures outlined on page 71
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 82 of this
manual.
If you are sending the image to an e-mail destination and need to change
the subject, use the procedure on page 82.
1
Load the document(s).
SEND READY will appear in the
display.
Press and/or to set
the resolution and contrast if needed.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
2
Press the appropriate Rapid Key.
The name of the recipient will appear in the display. (If the destination is not
correct, press within 5 seconds of pressing the Rapid Key.)
If the destination is an FTP or Desktop destination, or if the destination is
an e-mail destination and you dont need to enter a message or change any
of the e-mail options, this completes the procedure.
RESOLUTION
CONTRAST
STOP
all.bookPage87Wednesday,December18,20028:17AM
Page view 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 219 220

Comments to this Manuals

No comments