Sharp AR-5015 N Specifications Page 40

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 39
38
TWO-SIDED COPYING USING THE
BYPASS TRAY
To perform manual two-sided copying, follow these steps.
Example: Copying originals A and B onto each side of one sheet of paper
1
Copy original A.
2
Place original B as shown below.
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
3
Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
4
Select the bypass tray with the
[PAPER SELECT] key ( ), and then
press the [START] key ( ).
The copy is delivered to the paper output tray.
Original A
Original B
Copy
1
1
Original A
Copied original A
1
1
Original A
Copied original A
2
Original B
2
Original B
Copies made on the back side of paper
should always be made one sheet at a time
using the bypass tray.
Straighten curled or wavy paper before
using it. Curled paper may cause misfeeds,
creases, or a poor-quality image.
After placing the original, be sure to close the
document cover/SPF/RSPF. If left open,
parts outside of the original will be copied
black, causing excessive use of toner.
2
1
1
Original B
Copied
original A
2
1
1
Original B
Copied
original A
Note
Page view 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 107 108

Comments to this Manuals

No comments