Sharp SF-2530 Specifications download pdf (Page 58)

ADF (SF-A17)/RADF (SF-A56)

OPTIONAL EQUIPMENT

ADF (SF-A17)/RADF (SF-A56)

Stream feeding mode

The stream feeding mode allows easy operation of continuous

copying from the ADF or RADF. If the stream feeding mode has

been enabled using user program No. 5, the original feed

indicator will continue to blink for approximately 5 seconds after

feeding of all originals is completed. While this indicator is

blinking, any new originals placed in the document feeder tray

will be fed and copied automatically. If the stream feeding mode

has been disabled, the START key must be pressed each time

the originals are set even immediately after completion of a

copy run from the ADF or RADF. The default setting of the

stream feeding mode is “OFF”. See page 34, USER

PROGRAMS.

1-sided copies of 1-sided originals

Adjust the original guides to the size of the originals and

set the originals face up in the document feeder tray.

●

The ORIGINAL SIZE indicator for the detected original size will

light up, and the paper tray with the corresponding paper size

will be automatically selected.

●

The auto paper select function can be disabled using user

program No. 8. If this function has been disabled, use the TRAY

SELECT key to select the desired paper tray. See page 34,

USER PROGRAMS.

●

To copy onto a different size paper, use the TRAY SELECT key

to make the selection.

●

If an original is left on the document glass, the original reminder

indicator will blink. Remove the original from the document glass

in this case.

Using the ADF or RADF

●

Special originals such as transparency film and

tracing paper should not be fed from the ADF and

RADF, but should be placed on the document glass.

●

Duplex copying will not work when a non-standard

sized paper is used. (Duplex copying can be per-

formed only when an optional duplex module is

installed.)

●

Different size originals with the same width can be

placed in the document feeder tray and automati-

cally copied onto copy paper of their respective

sizes.

The automatic copy ratio selection will not function

in this case.

●

Image loss (max. 5/32" (4 mm)) can occur at the

leading and trailing edges of the copies.

●

Before loading originals into the document feeder

tray, be sure to remove any staples or paper clips

from them. The ADF or RADF can handle a maxi-

mum of 50 originals.

●

Damaged or crumpled originals may misfeed in the

ADF and RADF. It is recommended that these be

copied from the document glass and the copies be

used as original documents.

●

When feeding originals which have closely spaced

binding holes punched along an edge, place the

originals so that the punched edge is positioned to

the right or along the side guides.

Downloaded From ManualsPrinter.com Manuals

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 91 92

Comments to this Manuals

No comments

Sharp SF-2530 Specifications Page 58

Comments to this Manuals

Related products and manuals for Copiers Sharp SF-2530