Sharp PN-655 Instruction Manual download pdf (Page 47)

ENGLISH

■ If execution of the command is taking some time

If execution of a command takes some time,

WAIT may be returned as the returned value. In

this case, a value will be returned if you wait a

while. During this time, new commands will not

be received, even if they are sent.

No ID number is attached to WAIT response.

• Cases where WAIT is returned:

-When repeater control is used

- When an IDSL or IDLK command is used

- When one of the following commands is used: RSET, INPS, ASNC, WIDE, EMAG, EPOS, PXSL,

POWR

■ When control via RS-232C is locked (to prevent use) using the operation lock function (see

page 26)

■ If the current parameter is read out using “?” for the parameter (for numerical values etc.)

• Response when no ID number has been set

Example:

VOLM????

• Response when an ID number has been set (In the example below: ID number = 1)

Example:

VOLM????

10 001

• If the next command is sent in the interval before OK or ERR is returned, it will basically be ignored.

• Provide an interval of 100 ms or more between the command response and the transmission of the

next command.

IWTA

Return code

(0D

H, 0AH)

ECDKOL

Return code

(0D

, 0A

)

VOLM0020

INPS0001

WAIT

Interval of 100 ms or more

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 127 128

No comments

Sharp PN-655 Instruction Manual Page 47