Sharp XG-E1200U Instruction Manual download pdf (Page 12)

E-12

How to set up the projector and screen

Cautions: When setting up the projector

• Do not place it in humid or dusty places, or places where the air is sooty or full of cigarette smoke. If the lens,

mirror, or other optical components become dirty, the picture will blur or darken, making viewing difficult.

• Do not expose to extreme heat or cold.

Operating temperature: 41°F to 104°F (5°C to 40°C)

Storage temperature: 14°F to 140°F (120°C to 60°C)

• Do not tilt the projector more than 5°.

■ Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes out

colors, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or sunny

room.

■ The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector

and screen as shown.

SIDE VIEW

TOP VIEW

The projector lens should be centered

in the middle of the screen.

If the projector and screen are not

centered properly, the picture will be

distorted, making viewing difficult.

Lens center

■Using the horizontal reverse function makes the following setups possible.

Example of a reversed image setup

• By placing a mirror (normal flat type) in front of the lens and using the horizontal reverse function, the image

reflected from the mirror can be projected onto the screen.

• Rear projection with a rear projection screen is also possible when using the horizontal reverse function.

Rear Projection

If the projector and screen are not

centered properly, the picture will be

distorted, making viewing difficult.

The projector lens should be centered

in the middle of the screen.

AUDIENCE SIDE

▼

Mirror

Example of a standard setup

Lens center

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

No comments

Sharp XG-E1200U Instruction Manual Page 12