Sharp AR-FX7 Service Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
AR-FX7 ADJUSTMENTS 4 - 1
[4] OPERATION, DISPLAY SECTION
1. Operation panel
2. FAX mode (Condition setting screen)
The condition setting screen of fax mode is displayed by pressing the [FAX] key while the print mode, copy mode, or job status screen appears in the
touch panel. In the explanations that follow, it is assumed that the initial screen that appears after pressing the [FAX] key is the condition setting
screen (shown below). If you have set the display to show the address directory when the [FAX] key is pressed, touch the [CONDITION SETTINGS]
key in the address directory to display the condition setting screen.
A key operator program can be used to set the display to show either the condition setting screen (shown below) or the address directory screen (p.8)
when the [FAX] key is pressed.
A. Condition setting screen
The display is initially set (factory setting) to show the following screen when the [FAX] key is pressed.
No. Name Function, operation
1 Touch panel Messages and keys appears in the touch panel.
A key can be touched to select or enter a setting.
When you touch a key, a beep sounds and the key is highlighted to indicate that it has been selected.
Keys that cannot be selected in a screen are grayed out. If a grayed out key is touched, a double beep will
sound to indicate that the key cannot be selected.
2 Mode select keys Use to select the basic modes of the machine.
3 LINE light This lights while a fax is being sent or received.
4 Numeric keys Use for settings that require the entry of numbers.
5 [CLEAR] key This is used to clear a mistake when entering a number. One digit is cleared each time the key is pressed. The
key is also used to cancel scanning of an original.
6 [FAX] key Press to switch to fax mode. The initial screen of fax mode will appear in the touch panel display.
7 [JOB STATUS] key Use to check the status of a job.
8 DATA light This light blinks when a fax has been received to memory.
The light stays on constantly when a fax is waiting in memory for transmission.
9 [CUSTOM SETTINGS] key Use to customize the machine settings to better suit your needs. When using the fax function, destinations can
be stored and settings for fax reception and fax forwarding can be selected.
10 [ACC.#-C] key Press to use the fax function when auditing mode is enabled. This key can also be used to issue tone signals
when the machine is connected to a pulse dial line.
11 [START] key Press to begin scanning an original for fax transmission.
12 [CLEAR ALL] key Use to cancel a transmission or programming operation. When the key is pressed, the operation is canceled
and you return to the initial screen.
When sending a fax, this key is also used to cancel an image setting, paper size setting, or special function.
ACC.#-C
COPY
PRINT
SCAN
FAX
ON LINE
DATA
DATA
DATA
LINE
JOB STATUS
CUSTOM SETTINGS
910 1112
234 5
678
1
ADDRESS
BOOK
AUTO
READY TO SEND.
ORIGINAL
STANDARD
RESOLUTION
AUTO
EXPOSURE
SUB ADDRESS
ADDRESS REVIEW
SPECIAL MODES
REDIAL
SPEAKER
FAX MEMORY:100%
AUTO RECEPTION
DIRECT TX MEMORY TX
910
11
13
14
12
23 4
5
6
7
8
1
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 109 110

Comments to this Manuals

No comments