Sharp XG-NV6XM Specifications download pdf (Page 12)

Setup & Connections

2. Connecting the Projector

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.

Power cord

Connecting the Projector to a Computer

You can connect your projector to a computer for projection of full colour computer images.

Computer audio cable

QCNW-4870CEZZ

Computer cable

QCNW-5304CEZZ

1 To use the Standard 15-pin connector, slide the 15 pin/

BNC switch on the rear terminals to the 15 pin position.

2 Connect one end of the supplied computer cable to

the COMPUTER-RGB INPUT 1 or 2 port on the projector.

3 Connect the other end to the Monitor output port on the

computer. Secure the connectors by tightening the

thumb screws.

4 To use the built-in audio system, connect one end of

the supplied computer audio cable to the AUDIO INPUT

1 or 2 terminal on the projector.

5 Connect the other end to the Audio output terminal on

the computer.

CAUTION

• Before connecting, be sure to turn both the projector and the

computer off. After making all connections, turn the projector

on first. The computer should always be turned on last.

• Please read the computer’s operation manual carefully.

• Refer to pages 54 and 55 “Input Signals (Recommended Timing)” for a

list of computer signals compatible with the projector. Use with computer

signals other than those listed may cause some of the functions not to

work.

When connecting this projector to a computer, select

“Computer/RGB” for “Signal Type” on the GUI menu. (See

page 40.)

• A Macintosh adaptor may be required for use with some Macintosh

computers. Contact your nearest Authorised Sharp Industrial LCD

Products Dealer or Service Centre.

Connecting an IBM-PC or a Macintosh computer using the standard 15 pin Input

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

No comments

Sharp XG-NV6XM Specifications Page 12