Sharp DV-MX1U User's Guide Page 30
- Page / 216
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
18 Endcaps
MX1 Reference Guide E-EQ-MX1RG-D
Tools Required: #1 Phillips Screwdriver
1. ZIF Connector
2. Rubber O-Ring Gasket
3. O-Ring Gasket Slot
Figure 1-16 MX1 Endcap with O-Ring Gasket
1. ZIF Connector
2. ZIF Cable or Ribbon
Cable
3. Curved Edge
4. Middle Screw Set
Figure 1-17 Endcap and ZIF Ribbon Connector
Removal
1. Using a #1 Phillips screwdriver, remove the two screws securing the endcap. These screws
are located on the upper rear of the unit.
2. Loosen the two screws in the middle (number 4 on the figure titled “Endcap and ZIF Ribbon
Connector”. Do not remove middle screws.
3. When the top screws are removed detach the endcap and separate it from the MX1 unit no
more than the length of the ribbon connector still connecting the endcap to the unit.
4. Carefully lift up the lock mechanism on the ZIF connector.
Note: Use caution when performing this task since excessive pulling or twisting of the
connector may result in damage to either the unit, the endcap and/or the ribbon
connector.
5. Disconnect the ribbon cable from the ZIF connector in the endcap only.
6. If you anticipate keeping the endcap removed from the unit for a long period of time place the
endcap in an enclosed storage container. Store in an area that is protected from dirt, moisture,
and electrostatic contact.
- Reference Guide 1
- Notices 2
- Revision Notice 2
- MX1 Reference Guide 2
- HAPTER 1 INTRODUCTION 1 3
- Table of Contents iii 5
- HAPTER 5 UTILITIES 87 7
- Table of Contents vii 9
- PPENDIX A KEY MAPS 153 10
- Table of Contents ix 11
- Illustrations 12
- Chapter 1 Introduction 13
- When to Use This Guide 14
- Document Conventions 15
- Getting Started 16
- Components 19
- Insert Battery Pack 20
- Attach Hand Strap (Optional) 21
- Preparation 23
- Installation 24
- Removal 24
- Use and Operation 24
- Power On and Off 25
- Adjust Display and Volume 26
- Set The Display Contrast 26
- Set The Beeper Volume 26
- Endcaps 27
- RS-232 Endcap 27
- Plain Endcap 28
- Scanner Endcap Indicators 28
- ZIF Connector 29
- PCMCIA Card Slot 32
- PCMCIA Radio Card 34
- Data Entry 35
- Keyboard Data Entry 35
- Barcode Data Entry 35
- RS-232 Data Entry 35
- Getting Help 36
- Manuals and Accessories 36
- Manuals 36
- Accessories 37
- Hardware Configuration 39
- System Hardware 39
- Central Processing Unit 39
- ® 486 running at 25 MHz 39
- COM Ports 41
- PCMCIA Slot 41
- Physical Controls 42
- On/Off Switch 42
- Power Management and the 43
- Suspend State 44
- Critical Suspend State 44
- Panning 47
- Keypads 49
- Key Functions 50
- 2nd Key Function 51
- CTRL Key Function 51
- ALT Key Function 51
- SHFT Key Function 51
- SPC Key Function 51
- Reset Key Sequence 52
- Infrared (IR) Port 53
- IR Communication Reliability 53
- COM1 / COM2 54
- Scanner Endcaps 56
- Miscellaneous Connectors 57
- Handle Contacts 57
- Battery Charging Contacts 57
- Chapter 3 Power Supply 59
- Main Battery Pack 60
- Battery Charger Analyzer 60
- Low Battery Warning 61
- Backup Battery 61
- Battery Hot-Swapping 62
- Status LED and the Battery 62
- Handling Batteries Safely 63
- Indicators 66
- Installed Software 67
- Drive C Internal Flash Array 67
- Software Loaded on Drive C 68
- C Root Directory 69
- \DOS Files 69
- \PCMCIA Files 70
- Radio-Specific Subdirectory 72
- Sample AUTOEXEC.BAT File 73
- Sample CONFIG.SYS File 74
- Sample NET.CFG Files 75
- Cisco Radio NET.CFG File 76
- Symbol 4121 11Mb Radio 77
- NET.CFG File 77
- Sample SOCKET.CFG File 79
- 68 Installed Software 80
- LXE DOS Terminal Emulations 81
- Dual Terminal Emulation 82
- BIOS Setup 83
- Accessing the BIOS Setup 83
- Using the Keypad 84
- Main Menu Options 85
- Advanced Menu Options 89
- Power Management 90
- Keyboard 94
- Exit Menu Options 96
- API Calls 97
- Sample Code for API Calls 97
- Chapter 5 Utilities 99
- LXE BCWEDGE 100
- Parameters 100
- LXE Diagnostics 102
- Display Utility (DISP35.EXE) 105
- The NED ASCII Text Editor 109
- NED Default Hot Keys 110
- Serial File Transfer Utility 111
- REMSERV 111
- REMDISK 111
- IRSEND and IRECV Files 112
- IRSEND.C 112
- IRSEND and IRECV Files 101 113
- 102 IRSEND and IRECV Files 114
- IRECV.C 115
- 104 IRSEND and IRECV Files 116
- IRSEND and IRECV Files 105 117
- Introduction 119
- SNMP DOS Agent 119
- NET.CFG Parameters 120
- Lucent Parameters 120
- Microwave_Robustness 121
- Transmit_Rate 121
- Medium_Reservation 121
- Card_Power_Management 122
- Maximum_Sleep_Duration 122
- Receive_All_Multicasts 122
- Enable_Encryption 122
- Transmit_Key_ID 122
- Proxim Parameters 123
- Peer_to_peer 125
- Cisco Parameters 126
- Symbol Parameters 130
- SOCKETS TCP/IP Stack 132
- Set IP Address 133
- Set ARP INIT 133
- Set Interface 133
- Set Router IP (Gateway only) 134
- Set Domain Name Server 134
- Display IP Address 134
- Options 134
- SOCKET.CFG Parameters 135
- 1 128 5 248 140
- 2 192 6 252 140
- 3 224 7 254 140
- 4 240 8 255 140
- Chapter 7 Troubleshooting 147
- Startup Problems 149
- Verifying Boot Order 149
- Missing COMMAND.COM 150
- Copy File 151
- Setting System Time and Date 152
- Hardware Problems 153
- Power Source 153
- Display 154
- Hard Disk Drive 154
- PCMCIA Cards 155
- IRQ Assignments 156
- Optional Devices 157
- Radio Problems 158
- The 2.4GHz Radios 158
- The 900MHz Radios 158
- Software Related Problems 159
- IP Stack 159
- Conventional Memory 160
- Extended Memory 160
- System Testing 161
- Power On Self Test (POST) 161
- POST Error Messages 161
- POST Beep Codes 162
- Appendix A Key Maps 165
- Physical Specifications 179
- Environmental Specifications 180
- Display Specifications 181
- Battery Chargers 181
- Clip-on Portable Charger 181
- US AC Wall Adapter 181
- International AC Adapter 181
- Radio Specifications 182
- PCMCIA 900 MHz Type III 182
- PCMCIA Cisco 2.4 GHz Type II 183
- Appendix C Commands 185
- ATTRIB.EXE 186
- CHKDSK.EXE 187
- COMMAND.COM 188
- DELTREE.EXE 189
- FORMAT.COM 190
- HIMEM.SYS 191
- MEM.EXE 193
- MODE.COM 193
- MORE.COM 195
- NED.EXE and NED.CFG 196
- PRINT.COM 197
- REMDISK.EXE 198
- REMSERV.EXE 199
- SYS.COM 201
- XCOPY.COM 203
- ROM-DOS 6.22 Command Summary 204
Related products and manuals for DVD players Sharp DV-MX1U
DVD players Sharp SD-AS10H User Manual
(78 pages)
(78 pages)
DVD players Sharp DV-S1X Specifications
(24 pages)
(24 pages)
DVD players Sharp DV-SV80S(G) Specifications
(40 pages)
(40 pages)
DVD players Sharp SD-AS10W Specifications
(65 pages)
(65 pages)
(24 pages)
DVD players Sharp DV-NC70U Specifications
(109 pages)
(109 pages)
DVD players Sharp DV-RW370X Specifications
(100 pages)
(100 pages)
DVD players Sharp DV-SV97H Specifications
(44 pages)
(44 pages)
DVD players Sharp DV-SV80H Specifications
(41 pages)
(41 pages)
DVD players Sharp DV-720X Specifications
(58 pages)
(58 pages)
DVD players Sharp DV-560H Specifications
(55 pages)
(55 pages)
DVD players Sharp DV-760H Specifications
(63 pages)
(63 pages)
DVD players Sharp DV-720H User Manual
(8 pages)
(8 pages)
DVD players Sharp CD-DV999W Service Manual
(142 pages)
DVD players Sharp DV-HR300F Specifications
(109 pages)
(109 pages)
© 2020, manymanuals.com. All rights reserved. | 2.067 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals