Sharp DV-MX1U User's Guide download pdf (Page 20)

8 Components

MX1 Reference Guide E-EQ-MX1RG-D

Insert Battery Pack

Note: New batteries must be charged prior to first use. This process takes approximately three

hours in an LXE Battery Charger/Analyzer and eight hours with the LXE Clip-on

Portable Charger attached to the MX1.

The MX1 Battery Compartment is located on the lower rear of the computer. Open the Battery

Compartment door by sliding the door latch down (at the top of the compartment). Remove the

battery door.

Figure 1-3 Open Battery Door Figure 1-4 Inserting Battery Pack

Note: If a hand strap is attached to the unit, there is no need to remove the strap – just open the

closed loop fastener. See sections titled “Attach Hand Strap” and “Install Pistol Grip

Handle” for instruction.

These illustrations show the battery compartment with the door removed. The Battery Contacts (1)

provide the electrical link between the battery pack and the computer. Care should be used when

inserting or removing the battery pack so that damage does not occur to the contacts. If damage

does occur, cease using the unit until inspection or repair can be performed by a qualified

technician.

The MX1 Battery Pack should be inserted tab (2) end first so that the tab mates with the hole at

the top of the battery compartment. The battery will then lay inside the battery compartment but

will not be secure. To secure the battery, the battery compartment door must be in place and the

door latch locked. This provides the tension necessary to hold the battery pack in place.

Note: If a handstrap is installed, the battery door latch is hidden by the handstrap. Loosen the

handstrap and shift it out of the way to have access to the battery door.

1 ... 19 20 21 ... 216

No comments

Sharp DV-MX1U User's Guide Page 20