Sharp VL-NZ10S User Manual download pdf (Page 76)

Advanced Features

Playback

Advanced Features

61

Editing with the DV

Terminal (IEEE1394)

Available mode:

TAPE-VCR

This camcorder enables you to perform digital

video editing. Connect the camcorder to video

equipment with a DV terminal using the

supplied DV cable. The DV cable is able to

transfer all dubbing signals including video

and audio.

To Record from Video Equipment

(VL-NZ10 only)

1 Set the camcorder to TAPE-VCR mode,

and insert a Mini DV cassette.

2 Begin playback on the video equipment

connected to the camcorder.

• Check the camcorder screen to see if

the picture is properly received.

3 Press the REC START/STOP button on

the camcorder.

• The camcorder enters Recording

Standby mode.

4 Press m on the Operation button to

begin recording.

To stop recording

Press l on the Operation button.

Cutting Unwanted Sequences (VL-

NZ10 only)

1 Press m to pause recording when the

source tape reaches the beginning of

the sequence to be cut.

2 Press m to resume recording when the

source tape reaches the end of the

sequence to be cut.

Notes:

• Make sure that the video equipment from which

you are recording can output dubbing signals

via the DV terminal.

• If the video equipment is not set to playback

mode or the DV cable is not properly connected,

“NO SIGNAL” is displayed on the camcorder

screen.

• If no picture or sound is input to the camcorder

even if the DV cable is properly connected and

you are playing back the source media from the

video equipment, set the Power switch on the

camcorder to OFF and then back to VCR, or

disconnect the DV cable and connect it again.

• If a digital video recording with a copyright

protection signal is used as the playback source,

“COPYRIGHT PROTECTED.” appears on the

camcorder monitor and the recording function is

disabled (see page 87).

To Record to Video Equipment

See “Cutting Unwanted Sequences” on page

60, using the video equipment as the recording

source.

Note:

• Make sure that the video equipment to which

you are recording can input dubbing signals via

the DV terminal.

To DV terminal

To DV terminal

DV cable (supplied)

Video equipment

with DV terminal

(e.g. DV camcorder)

1 ... 75 76 77 ... 111

Comments to this Manuals

No comments