Sharp VL-NZ10S User Manual download pdf (Page 25)

Preparation

10

Attaching and Removing

the Battery Pack

Attaching the Battery Pack

1 Make sure that the Power

switch is set to OFF.

2 Align the = mark on the side of the

battery pack with the = mark on the

camcorder (1), and slide the battery

pack in the direction of the arrow

completely until it locks into place (2).

Removing the Battery Pack

1 Make sure that the Power switch is set

to OFF.

2 Rotate the monitor section of the

camcorder (1), then press the power

source release (2). Slide the battery

pack in the direction of the arrow and

take it out (3).

Cautions:

• BEFORE REMOVING THE BATTERY PACK,

ALWAYS STOP RECORDING OR PLAYBACK

AND TURN THE POWER OFF. Removing the

battery pack while shooting or during playback

may damage the tape by causing it to wrap

around the video head drum or destroy the card,

rendering it unreadable and unwritable.

• Remove the battery pack from the camcorder if

you will not use the camcorder for a long period

of time.

• Make sure that the battery pack is firmly

attached during operation. If it is not, the battery

pack may come off or camcorder operation may

fall because of the poor contact pressure.

• To prevent damage to the battery pack when

removing, be sure to firmly hold the battery pack

while pressing the release.

• Use only SHARP model BT-L225 or BT-L445

battery packs with this camcorder. Use of other

batteries may create a risk of fire or explosion.

Power switch

Power source

release

1 ... 24 25 26 ... 111

Comments to this Manuals

No comments