Sharp AN-WC11B Specifications download pdf (Page 23)

Introduction

-19

Using the GyroRemote

Info

• The GyroRemote emit s operation signals

according to the angle and change of

angle of the GyroRemote.

• You can smoothly operate the

GyroRemote just by turning your wrist.

• The movements of the GyroRemote send

signals to the projector while holding down

on the rear of the GyroRemote.

• If is not held down, the movements

of the GyroRemote do not send signals

to the projector.

• If is pressed twice, the GyroRemote

will continuously send signals to the

projector. Pressing again will return

the GyroRemote to its normal condition.

Calibrating the

GyroRemote

If there are any extreme temperature changes

when the GyroRemote is being used or after

batteries have been replaced, the mouse

cursor or pointer may continue to move by

itself even if no action has been performed. In

this case, calibrate the GyroRemote using the

following procedure.

1 Press on the rear of the

GyroRemote twice.

2 Make sure that the LED

indicator is lit, and place the

GyroRemote on a leveled

location.

• After leaving the GyroRemote for 6

seconds, the calibration of the

GyroRemote is complete.

3 Press , after leaving the

GyroRemote for more than 6

seconds.

• Calibration is complete after the

remote has been left for more than 6

seconds.

GYRO ACTIVE

button

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 130 131

Comments to this Manuals

No comments