Sharp M450U Setup Guide Page 32

  • Download
  • Add to my manuals
  • Print
  • Page
    / 93
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 31
2-15
SCANNING SETTINGS (ORIGINAL SIZE,
EXPOSURE, RESOLUTION AND FILE FORMAT)
When sending an image, you can adjust the original size, exposure, resolution, and file format settings as needed.
MANUALLY SETTING THE SCANNING SIZE
If you load an original that is not a standard size (such as an inch size), or if you wish to change the scanning size,
touch the [ORIGINAL] key and set the original size manually.
Perform the following steps after loading the document in the automatic document feeder or on the document glass.
1
Touch the [ORIGINAL] key.
2
Touch the [SCAN SIZE] key.
The sizes that can be
selected are displayed.
3
Touch the desired original size key.
[AUTO] is no longer
highlighted. [MANUAL]
and the original size key
you touched are
highlighted.
If you wish to select an inch size, touch the
[INCH] key and then touch the desired
original size key.
[INCH] is highlighted
and inch size keys are
displayed.
To return to the AB
palette, touch the [AB]
key once again.
If you wish to select a custom size, touch
the [SIZE INPUT] key and enter the size of
the original
Touch the [X] key and
use the or keys
to set the length in the X
direction, and then touch
the [Y] key and do the
same for the Y direction.
The length can be within
the range 64 to 432 mm
(2-1/2" to 17") in the X direction and 64 to 297 mm
(2-1/2" to 11-5/8") in the Y direction, set in
increments of 1 mm (1/8").
When using the automatic document
feeder, a setting for originals longer than
432 mm (17") (800 mm (31-1/2") at the
maximum) is available. In this case, touch
the [LONG SIZE] key.
NOTE
Standard sizes that can be detected are as follows:
A3, B4, A4, A4R, B5, B5R, A5 (11"x17", 8-1/2"x14", 8-1/2"x11", 8-1/2"x11"R, 5-1/2"x8-1/2")
If a non-standard size original is loaded (including special sizes), the closest standard size may be displayed, or
the original size may not appear at all.
NOTE
If you wish to rotate the original 90° when creating an
image file, touch the "ROTATE THE IMAGE 90
DEGREES" checkbox (a checkmark should appear
in the box). (only in the SCAN mode)
ORIGINAL
300
x
300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO A4
OK
INCH
LONG SIZE
STANDARD SIZE SIZE INPUT
AB
5
X
8
8
X
14
8
X
13
11
X
17
2
1
8
X
11R
2
1
8
X
11
2
1
2
1
2
1
2
1
5
X
8 R
2
1
2
1
MANUAL
420
X
297
(64 432)
mm
(64 297)
mm
Y
AUTO
STANDARD SIZE
MANUAL
CUSTOM
SIZE
SIZE INPUT
Page view 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 92 93

Comments to this Manuals

No comments