Sharp DV-MX1U User Manual download pdf (Page 10)

10 LokSoundXL User Manual V2.1 05/2002

precise.) They are easy to install. A commonly used

module is the Siemens / Infineon TLE4905 available at

electronic stores.

Connect terminal Vs of TLE4905 to terminals 1-4,

GMD to terminal 1-4 and Pin Output to terminal 1-7.

Before you can use the wheel sensor certain CVs

have to be set. See chapter 5.2.4

3.7.4 Connecting auxiliary reed switches

As from version 2.0 the LokSoundXL decoder has

two additional inputs. You can use them to release

sound effects with the help of trackside magnets.

Just connect a reed sensor to the inputs and place a

magnet at the appropriate location on the layout.

The required sound effect will be activated every time

the locomotive passes the magnet.

With the aid if these inputs users of LGB MZS with

Lokmaus may activate the multitude of sound effects

generated by LokSoundXL decoders.

Both inputs REED-IN1 and REED-IN2 share

terminal 2-7 as well as 2-8 with function outputs

AUX5 and AUX6. If you want to use the REED-

IN functions then AUX5 and 6 are not available.

Before you can use reed sensors certain CVs

have to be set. See chapter 5.2.7

4. Set Up and installation of the decoder

After successful installation you may operate the

decoder.

But first you will find out how to check your

installation. In chapter 4.1 you will find instruction of

how to operate the decoder in analogue mode. In

chapter 4.2 you learn how to operate it with various

digital systems.

Before changing any decoder settings (e.g. locomotive

address, sound volume) we recommend to read

chapter 5 . There you find out which parameters are

available and how they may be altered with the

commonly available DCC command centers.

After installation you may test the LokSoundXL

decoder as follows.

Please inspect all connections carefully using an

ohmmeter: are there any short circuits between

the motor terminals and the wheel pick-ups?

Have all connections between motor terminals

and the chassis been isolated? Are bulbs

connected properly and isolated from the

chassis? Is the decoder installed safely to avoid

contact with the chassis? Is there sufficient space

around the LokSoundXL decoder to allow for

cooling? Could the LokSound 2 decoder or any

of the wires be squeezed when refitting the

housing? May sound emit from the locomotive

without obstruction?

Connecting auxiliary reed switches

figure 8figure 8

figure 8: connecting a Hall sensor

1-1

1-2

1-3

1-4

1-5

1-6

1-7

1-8

1-9

GND

Output

TLE4905

driving axle

Miniature magnet

resistor 10k 0,25W

Reed switches

REED-IN1

REED-IN2

figure 9figure 9

figure 9: connecting auxiliary reed switches

1-1

1-2

1-3

1-4

1-5

1-6

1-7

1-8

1-9

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Sharp DV-MX1U User Manual Page 10

Comments to this Manuals

Related products and manuals for DVD players Sharp DV-MX1U