Sharp SF-1014 Service Manual download pdf (Page 41)

3. Fuser section

3-1. Fuser unit removal

1 Open the front panel

2 Remove the table glass.

3 Turn the open/close lever to the right and open the upper unit

slowly.

4 Remove the connectors (2 pin × 2), slightly lift the right side of the

unit and pull it out.

5 Move the copy lamp unit to the left of the body (the paper exit

side).

6 Disconnect the connector (2-pin) of the dehumidifier heater which

extends from the dark box cover. Insert a long screwdriver (+) into

that port and remove the screw which is fixing the fuser cover.

7 Remove the fuser cover in the direction of arrow A.

8 Remove an E-ring and two connectors.

3-2. Heater lamp replacement

1 Remove the fuser cover fixing screw (1 pc.), and slide it to the

front side, and remove it.

2 While pushing the projection of the Faston terminal connected to

the thermostat, remove the lead wire from the connected section.

3 Remove the lamp holder fixing screw on the top of the rear frame,

and remove the holder.

4 Pull out the heater lamp from the front frame.

For assembly, reverse the disassembly procedures.

6 – 6

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 152 153

No comments

Sharp SF-1014 Service Manual Page 41