Sharp AR-PB2A Service Manual download pdf (Page 14)

10) Remove the securing screws holding the P side OP cover in the

rear lower cover which was removed in the step 2, then remove

the P side OP cover.

Next, paste an attached label at the position only for Sweden

and Norway as shown in the illustration.

11) Hook the rear lower cover on the securing screw ➃ which was

loosened in the step 2 as shown in the illustration.

Next, tighten the securing screws ➀, ➁ and ➂ temporarily, which

were removed in the step 2 and tighten the securing screw ➃

which was loosened, then tighten the securing screws ➄, ➅ and

➆.

Reinstall the rear cover which was removed in the step 2 to the

original position by putting it onto the securing screws ➀, ➁ and

➂ which temporarily secure the rear cover, then tighten the

securing screws ➀, ➁ and ➂ after tightening the securing screws

➇ and ➈.

If the rear cabinet is a box type, attach the connector cover.

12) If the rear cabinet is a box type:

Insert the printer relay cable connector to the rightmost connec-

tor of the ICU PWB to connect it.

If an option has been already connected to the right SCSI con-

nector of the copier, however, connect the cable to the left con-

nector.

13) If the copier is equipped with an automatic document feeder,

connect the connector that has been removed in step 2 to its

original position of the copier and secure the connector with the

attached screw.

1. Connect the printer relay cable to the connector of printer

box.

2. Attach the supplied wire saddles to the printer relay cable.

3. Insert and fix the wire saddle at the position of rear lower

cover as shown in the illustration.

(2) Expansion memory installation

a. Memory expansion in the printer control PWB

Normally there is no need for memory expansion. However,

memory expansion will increase the printer performance.

When printing graphics or complex data, memory expansion will

increase printing speed.

Memory of 16MB or 32MB can be installed to the two slots. (16MB

onboard)

Different capacity of memory can be installed to the two slots.

The total memory after expansion may be 32, 48, 64, or 80MB.

After the above procedure, select VM Option menu and set the

total memory capacity.

b. ICU PWB memory expansion

The copier ICU PWB requires total memory capacity of 16 (20)MB

or more.

Memory of 16MB or 32MB can be installed to the two slots. (4MB

onboard)

Different capacity of memory can be installed to the two slots.

B. Stand-alone environment (Printer (parallel)

cable connection)

Plug the connector of the Centronics cable (sold separately) into the

Centronics port on the printer box base.Plug the other connector into

the laser printer port on a personal computer.

P side OP cover

Label

Securing

screws

Securing screw

Securing

screws

Securing

screws

Rear lower

cover

Rear lower

cover

Rear cover

Loosened

screw

Loosened

screw

Rear

cover

Securing screw

Connector

cover

•

If the rear cabinet is a box type:

Screw

Connector

Printer relay cable

Wire saddle (1 pc.)

Wire saddles (2 pcs.)

•

If the rear cabinet is a box type:

Centronics cable

(sold separately)

Connector going to the

laser printer port on the

personal computer

AR-PB2A

3 – 3

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments

Sharp AR-PB2A Service Manual Page 14

Comments to this Manuals

Related products and manuals for Copiers Sharp AR-PB2A