Sharp AR-PB2A Service Manual download pdf (Page 15)

C. Network environment (Network card installation)

1) Insert the network card into the network card slot on the printer

control PWB. and fix it with screws.

2) Install the printer control PWB to the copier.

3) Connect the network cable to the network card connector.

4. Setup on the copier side

A. Setup by simulation

Setup the following items. For parallel I/F, setup, if there is no trouble

in operations, there is no need to change any settings.

Content Simulation No. Set value

System configuration setup 26-44 1

Print counter count mode setup 26-05

Parallel I/F timing adjustment 67-03

Parallel I/F select IN signal timing 67-11

B. Setup by key operator program

Refer to the section of the key operator program and make setting

according to the user environment.

5. Software installation and setup

Checking the Hardware and Software Requirements

You will need the following hardware and software in order to install

the printer driver.

(Windows)

Computer Type • IBM PC/AT or compatible computer

equipped with a bi-directional parallel

interface

Operating System • Windows 3.1x, Windows 95, Windows 98,

Windows 2000, Windows NT 4.0

CPU • Windows 3.1/Windows 95: 486SX or better

• Windows 98: 486DX/66 MHz or better

(Pentium or better is recommended.)

• Windows NT4.0: 486/25MHz or better

RAM • Windows 3.1/Windows 95: 8 MB or more

(12 MB or more is recommended.)

• Windows 98/Windows 2000: 16 MB or more

(32 MB or more is recommended.)

• Windows NT 4.0: 16 MB or more

(Macintosh)

Operating system • Mac OS 7.6 to 9.0

CPU • MC 68040 or PowerPC microprocessor

RAM • 16 MB or more for PowerPC microprocessor

machine

• 12 MB or more for MC 68040 machine

Printer driver • LaserWriter 8 version 8.4.1 or later

To use the printer with a Macintosh computer, an optional network

interface card (Print Server Card) is needed. Also the Macintosh com-

puter must be equipped with an Ethernet port. If your computer is not

equipped with an Ethernet port, install an Ethernet interface.

6. Setup under network environment

Check the user environment and make setup according to the Opera-

tion Manual attached to the network card.

A. Outline of the NW Setup

The NW Setup is a setup tool for using a SHARP printer with a

network card installed in a Novell NetWare environment. Registration

of printers to a NetWare server and parameter settings for a network

card can be performed by using a procedure with wizards.

For using the NW Setup, a Novell Client supplied by Novell must

have been installed. Also before starting the NW Setup, you must log

in the NetWare server with the ’Administrator’ privileges.

AR-PB2A

3 – 4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments

Sharp AR-PB2A Service Manual Page 15

Comments to this Manuals

Related products and manuals for Copiers Sharp AR-PB2A