Sharp CV-P09LX User Manual download pdf (Page 23)

ENGLISH

DEHUMIDIFICATION MODE

Remove the exhaust hose (See Page 17)

Turn the drainage nozzle to the OPEN position.

Pull the stopcock out from the drainage nozzle.

• When the stopcock is removed, a small amount of water

may be discharged from the drainage nozzle.

• Always perform this procedure with the unit turned off.

Drain water will spout out if attempted during operation.

Insert the hose clamp onto a standard commer-

cially-available hose (5/8" inner diameter, 7/8" outer

diameter) and attach the drain grommet to the

hose.

Attach the hose to the drainage nozzle, and secure

it with the hose clamp.

• Insert the hose securely into a container with a minimum

capacity of 3

gallons. Be sure to monitor the water level

in the container and empty as necessary. Do not operate in

dehumidify mode for more than 8 hours at a time. Be sure

to empty the water container whenever dehumidify mode is

started. Failure to empty the water container can cause the

container to overflow and cause damage to underlying

materials.

• Set the hose sloping downwards for easier drainage.

Moreover, do not bend the hose at any point, nor allow

the end to be submerged in water.

Dehumidification with no container

E-21

In this mode, the air conditioner dehumidifies the room.

CAUTION

When operating dehumidification with container, the unit generates heat during dehumidifica-

tion mode and the room temperature will rise. Operate dehumidification with no container if

you don't want the room temperature to rise. This will help to slightly drop the room

temperature, but dehumidification performance will become less effective than when operat-

ing dehumidification with container.

Press the MODE button to select DEHU-

MIDIFICATION mode.

COOL DEHUM FAN VENT

Press the power button to start opera-

tion.

• The red OPERATION lamp on the unit will light.

• The temperature cannot be set.

• The fan speed is preset to AUTO and cannot be

changed.

TO TURN OFF

Press the POWER button again.

• The red OPERATION lamp on the unit will turn off.

Dehumidification with container

Drainage nozzle

Stopcock

Drain grommet

Hose clamp

Hose

If draining of the water is not desirable, install the exhaust hose (See Page 16), turn the drainage nozzle to the

CLOSE position, and check that the drainage nozzle is covered with the stopcock. In this operation, the water

tank inside the unit may be full, the unit stops operating and then the TIMER, OPERATION and MEGA COOL

lamps are blinking, depending on room condition. In this case, drain out the water within the unit (See Page 29).

"OPEN" position

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 95 96

Comments to this Manuals

No comments

Sharp CV-P09LX User Manual Page 23

Comments to this Manuals

Related products and manuals for Conditioners Sharp CV-P09LX