Sharp QT-80W Instruction Manual download pdf (Page 28)

3.1.2.1 ECG in 30 mm height

Typical values for C

ombi-Wiring terminals of ECG with 30 mm height are:

a) Single-core cables

These should have a cross section of 0.5mm² at least and 1.5 mm²

at most for the horizontal plug.

When using I

nsulation Displacement Contacts (IDC) cables should

have a maximum cross section of 0,5 mm²

b) Multi-core cables

horizontal plug

These should have a cross section of 0,5 mm² at least and 1 mm² at

most.

Multi-core cables can be inserted directly into the horizontal plug

terminals.

Ferrules may be used but they are not essential.

IDC

Multi-core cables with a cross section of 0,75 mm² can be used for

direct wiring with IDC.

3.1.2.2 ECG in 21 mm height

Typical values for C

ombi-Wiring terminals of ECG with 21 mm height are:

c) Single-core cables

These should have a cross section of 0,5 mm² at least and 1 mm² at

most for the horizontal plug.

When using I

nsulation Displacement Contacts (IDC) cables should

have a maximum cross section of 0,5 mm²

d) Multi-core cables

horizontal plug

These should have a cross section of 0,5 mm² at least and 1 mm² at

most.

Multi-core cables can be inserted directly into the horizontal plug

terminals.

Ferrules may be used but they are not essential.

IDC

Multi-core cables with a cross section of 0,75 mm² can be used for

direct wiring with IDC.

3.1.3 Release of Contacts

3.1.3.1 WAGO 250

Release the contact by using the release latch.

3.1.3.2 WAGO 251 – IDC

Release the contact by pulling the cable upwards.

This process can be repeated up to 10 times (depending on the

manufacturer) without damaging the terminal. For further details please

refer to the data sheets of the manufacturers.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 92 93

Comments to this Manuals

No comments

Sharp QT-80W Instruction Manual Page 28

Comments to this Manuals

Related products and manuals for Cassette players Sharp QT-80W