Sharp MD-SR60E Instruction Manual download pdf (Page 88)

Controlling Other Components

—Continued

Remote Control Codes for Onkyo

Components Connected via

Onkyo components that are connected via are con-

trolled by pointing the remote controller at the AV

receiver, not the component. This allows you to control

components that are out of view, in a rack, for example.

If you want to control an Onkyo component by pointing

the remote controller directly at it, or you want to control

an Onkyo component that’s not connected via , use

the following remote control codes:

•[DVD] REMOTE MODE button

30627:

Onkyo DVD player without (default)

• [CD] REMOTE MODE button

71817:

Onkyo CD player without (default)

Note:

• If you connect an -capable Onkyo MiniDisc

recorder, CD recorder, or RI Dock to the TAPE

IN/OUT jacks, or connect an RI Dock to the

GAME/TV jacks, for to work properly, you must

set the Input Display accordingly (see page 45).

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default

remote control code.

You can reset the remote controller to its default settings.

Make sure the Onkyo component is con-

nected with an cable and an analog

audio cable (RCA).

See page 36 for details.

Enter the appropriate remote control code

to the REMOTE MODE button.

•[DVD] REMOTE MODE button

31612:

Onkyo DVD player with

• [CD] REMOTE MODE button

71327:

Onkyo CD player with

•[TAPE] REMOTE MODE button

42157:

Onkyo cassette recorder with

(default)

See the previous page for how to enter remote

control codes.

Press the REMOTE MODE button, point

the remote controller at the AV receiver,

and operate the component.

While holding down the REMOTE

MODE button that you want to

reset, press and hold down the

[AUDIO] button until the Remote

indicator lights up (about 3 sec-

onds).

Within 30 seconds, press the

REMOTE MODE button again.

The Remote indicator ﬂashes twice,

indicating that the button has been

reset.

Each of the REMOTE MODE buttons

is preprogrammed with a remote con-

trol code. When a button is reset, its

preprogrammed code is restored.

Resetting the Remote Controller

While holding down the

[RECEIVER] REMOTE MODE but-

ton, press and hold down the

[AUDIO] button until the Remote

indicator lights up (about 3 sec-

onds).

Within 30 seconds, press the

[RECEIVER] REMOTE MODE but-

ton again.

The Remote indicator ﬂashes twice,

indicating that the remote controller

has been reset.

(3 seconds)

TX-SR606_En.book Page 88 Wednesday, March 5, 2008 10:30 AM

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 103 104

Comments to this Manuals

No comments

Sharp MD-SR60E Instruction Manual Page 88

Comments to this Manuals

Related products and manuals for AV receivers Sharp MD-SR60E