Sharp MD-SR60E Instruction Manual download pdf (Page 87)

Controlling Other Components

You can control your DVD player, CD player, and other

components with the AV receiver’s remote controller.

To control another component, you must ﬁrst enter that

component’s remote control code to a REMOTE MODE

button.

This section explains how to enter remote control codes

and how to control your other components.

The following REMOTE MODE buttons are prepro-

grammed with remote control codes for controlling the

components listed. You do not need to enter a remote

control code to control these components.

For details on controlling these components, see the

pages indicated.

Onkyo DVD player (page 90)

Onkyo CD player (page 93)

Onkyo cassette recorder with (page 95)

You’ll need to enter a code for each component that you

want to control.

Note:

• The remote control codes provided are correct at the

time of printing but subject to change.

Preprogrammed Remote Control

Codes

Entering Remote Control Codes

REMOTE

MODE

DISPLAY

Number

buttons

Remote

indicator

Look up the component’s remote

control code in the separate

Remote Control Codes list.

The codes are organized by category.

While holding down the REMOTE

MODE button to which you want

to enter a code, press and hold

down the [DISPLAY] button until

the Remote indicator lights up

(about 3 seconds).

Note:

• Remote control codes cannot be

entered for the [RECEIVER] and

[ZONE 2] REMOTE MODE but-

tons.

• Only TV remote control codes can be

entered for the [TV] REMOTE

MODE button.

• Apart from the [RECEIVER], [TV],

and [ZONE 2] REMOTE MODE

buttons, remote control codes from

any category can be entered for the

REMOTE MODE buttons. However,

these buttons also work as input

selector buttons (page 47), so choose

a REMOTE MODE button that cor-

responds with the input to which you

connect your component. For exam-

ple, if you connect your CD player to

the CD input, choose the [CD]

REMOTE MODE button when

entering its remote control code.

Within 30 seconds, use the num-

ber buttons to enter the 5-digit

remote control code.

The Remote indicator ﬂashes twice.

If the remote control code is not entered

successfully, the Remote indicator will

ﬂash once slowly.

(3 seconds)

TX-SR606_En.book Page 87 Wednesday, March 5, 2008 10:30 AM

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 103 104

Comments to this Manuals

No comments

Sharp MD-SR60E Instruction Manual Page 87

Comments to this Manuals

Related products and manuals for AV receivers Sharp MD-SR60E