Sharp YO-370 Manual download pdf (Page 34)

22 Revision 10 – 1/09/2015 FTS 370d/w/r

Securing the Cable

Flash Technology provides the material

for securing the flashhead cable to a

skeletal structure with the following

technique. Always adhere to local

electrical codes that could supersede this

recommended technique:

1. Run the cable along one of the tower

legs and wrap two full turns of two-

inch Scotchrap™ #50 tape, or the

equivalent, around the cable and tower

leg at regular intervals every 4 to 5 feet

(1.5 meters) per NEC.

2. Wrap three full turns of one-inch

Scotchrap Filament #890 tape, or the

equivalent, over the Scotchrap #50

tape.

3. Wrap four full turns of two-inch

Scotchrap #50 tape, or the equivalent,

over the Scotchrap Filament #890 tape.

4. Perform steps 1 through 4 also directly

above and below any tower leg flanges

that the cable may cross. The cable

should be spaced approximately 1 inch

from the edge of each flange.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 117 118

No comments

Sharp YO-370 Manual Page 34