Sharp XG-E1200U User Manual download pdf (Page 9)

Extron • System 8/10 P

LUS

• User’s Manual • P/N 68-409-01 Rev. C

Sharp Installation Configuration and Connections

Page 9

System 8/10 Plus - Sharp NV6 Projector Connections

Use the illustration below as a guide when connecting the System 8/10 Plus to a

Sharp NV6 projector. Refer to Sharp documentation to continue the installation.

________ Important note! When connecting the Switcher’s BNC output to either the

projector’s BNC or 15-pin input (but not both simultaneously), set the projector’s

input type selector switch to the appropriate “BNC” or “15-pin” setting.

________ The Sharp NV6 projector does not allow simultaneous connections to S-Video

and Composite Video (see last note on previous page), please refer to the

following diagram where either S-Video or Composite Video may be connected,

but not both at the same time.

________ If the installation includes looping (master/slave) switchers, see Chapter 5 of the

System 8/10 Plus User’s Manual.

________ If Video Loop Back is part of the installation, refer to pages 2-10 and 2-11.

RGBHV 5 BNC

15-Pin

Male

Composite

Video

S-Video

Sharp NV6 Connect.eps

9-Pin Female

Universal

CommAdapter

26-467-01

9-Pin Male

CC cable

input type

selector switch

Important note!

Composite Video and S-video

output to the projector may not

be connected simultaneously

Sharp RS-232C cable

1 2 3 4 5 6 7 8 9 10 11

No comments

Sharp XG-E1200U User Manual Page 9