Sharp XG-E1200U User Manual download pdf (Page 10)

Extron • System 8/10 P

LUS

• User’s Manual • P/N 68-409-01 Rev. C

Sharp Installation Configuration and Connections

Page 10

Sharp NV3 Projector Configuration

Verify that the System 8/10 Plus is already configured for the Sharp NV3

projector by following the procedure and switch settings below. The general

setup is explained on page 3-4 of your System 8/10 Plus User’s Manual.

1. Use a small screwdriver to remove the access cover from the System 8/10 Plus

front panel. Refer to page 3-3 of the User’s Manual.

__________ Before changing anything, remove the AC power cord to the System 8/10 Plus

and also turn the projector’s power OFF.

2. Set the System 8/10 Plus switches as follows:

Config Model Rotary Switches Cable SW15 Settings Comm

as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter

Sharp NV3 1 0 F 9 J2 ↑↓↑ ↓↑↓ ↓↓

↑↓ 26-467-01

3. Locate the switcher’s Address DIP switches on the rear panel, lower right.

Unless this is part of a master/slave system, set #3 and #5 to the up position and

the others in the down position. See illustration on the left.

4. Use the illustration on the following page and continue with the steps below.

5. Connect the video cables from the System 8/10 Plus outputs to the projector

inputs according to the application requirements (RGBS, S-Video or Composite

Video). One end of the Universal Comm adapter plugs into the IOIOI port of the

Sharp PC Control adapter. The Sharp PC Control adapter plugs into the

projector’s PC Control port 1.

________ The projector’s RGB BNC input will not accept rates lower than VGA or higher

than XGA. Please refer to your projector user manual.

________ Because the projector’s video port will only select S-Video when connected to an

S-Video source, you should not input S-Video and Composite Video sources

simultaneously since Composite Video will be ignored.

6. Apply Main Power to the System 8/10 Plus by connecting the power cord. The

Main Power LED should light. Apply power to the projector.

7. Installation is now completed.

Configured For:

RS-232

SW15 DIP Switch

RS5 RS2

RS2

RS1

RS3

RS4

RS1

RS3 RS4

3456789101

1 2 ... 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Sharp XG-E1200U User Manual Page 10

Comments to this Manuals

Related products and manuals for Projectors Sharp XG-E1200U