Sharp KB-3300J Service Manual download pdf (Page 12)

KB-3300JS

KB-3300JK

KB-3300JW

DRILL PILOT HOLES AND FASTEN BRACKET

Drill a

/8-inch pilot hole where screws are to be located. If bracket

is to be mounted to the wall, drill pilot hole at an approximate 20

degree downward angle. If bracket is to be mounted to masonry or

ceramic floors, drill a

/32-inch pilot hole 1

/4-inches deep. The

screws provided may be used in wood or concrete material. Use a

/16-inch nut-driver or flat head screwdriver to secure the bracket

in place.

FASTEN BRACKET

(WALL OR FLOOR MOUNTING)

FASTEN BRACKET

(FLOOR MOUNTING ONLY)

Floor Mount

Anti-Tip Bracket

Wall

Wall Mount

Wall Plate

More Than

Max 1

Leveling Leg

LEVEL AND POSITION RANGE

Level range by adjusting the (4) leveling legs with a wrench. Note:

A minimum clearance of

/8-inch is required between the bottom

of the range and the leveling leg to allow room for the bracket. Use

a level to check your adjustments. Plug range into properly prepared

electrical receptacle or if hard wired, check that it was completed

properly. Check door condition for evenness and stability. Slide

range back into position.

Visually check that rear leveling leg is inserted into and fully secured

by the Anti-Tip bracket by looking underneath the range with a

fl ashlight and carefully attempt to tilt it forward.

ANTI-TIP DEVICE

NORMAL INSTALLATION STEPS

ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS

IMPORTANT SAFETY WARNING

To reduce the risk of tipping of the range, the range must be secured

to the floor by properly installed Anti-Tip bracket and screws packed

with the range. Failure to install the Anti-Tip bracket will allow the

range to tip over if excessive weight is placed on an open door or if

a child climbs upon it. Serious injury might result from spilled hot

liquids or from the range itself.

If range is ever moved to a different location, the Anti-Tip bracket

must also be moved and installed with the range. Instructions are

provided for installation in wood or cement fastened to either the floor

or wall. When installed to the wall, make sure that screws completely

penetrate dry wall and are secured in wood or metal. When fastening

to the fl

oor or wall, be sure that screws do not penetrate electrical

wiring or plumbing.

LOCATE THE BRACKET - USING THE TEMPLATE

The bracket may be located on either the left or right side of the

range. Use the information below to locate the bracket if template

is not available.

Mark the floor or wall where left or right side of the range will be

located. If rear of range is against the wall or no further than 1

/4-

inches from wall when installed, you may use the wall or floor mount

method. If molding is installed and does not allow the bracket to fit

push against the wall, remove molding or mount bracket to the floor.

For wall mount, locate the bracket by placing the back edge of the

template against the rear wall and the side edge of template on the

mark made referencing the side of the range. Place bracket on top

of template and mark location of the screw holes in wall. If rear of

range is further than 1

/4-inches from the wall when installed, attach

bracket to the floor. For floor mount, locate the bracket by placing

back edge of the template where the rear of the range will be located.

Mark the location of the screw holes, shown in template.

Figure 18

Range Slide

Figure 15

Figure 16

Figure 17

1 ... 11 12 13 ... 72

Comments to this Manuals

No comments

Sharp KB-3300J Service Manual Page 12

Comments to this Manuals

Related products and manuals for Microwaves Sharp KB-3300J