Sharp MX-C310 Specifications download pdf (Page 22)

PLACING ORIGINALS

The automatic document feeder can be used to automatically scan many

originals at once. This saves you the trouble of manually feeding each original.

For originals that cannot be scanned using the automatic document feeder,

such as a book or a document with notes attached, use the document glass.

Using the automatic document feeder

When using the automatic document feeder, place the originals in the

document feeder tray.

Make sure an original has not been placed on the document glass.

Using the document glass

Take care that your fingers are not pinched when closing the automatic

document feeder.

After placing the original, be sure to close the automatic document feeder. If

left open, parts outside of the original will be copied black, causing

excessive use of toner.

Adjust the original guides

to the width of the originals.

Place the originals face up with the edges

aligned evenly.

The indicator line indicates approximately

how many originals can be placed. The placed

originals must not be higher than this line.

Place the original face down.

Align the middle of the original

with the tip of the mark in the

centre of the glass.

To place a thick original such as a book,

push up the far edge of the automatic

document feeder and then close the

automatic document feeder slowly.

Do not press hard on the automatic

document feeder. This may cause failure.

Place the original

face down.

mxc381_ex_qck.book 20 ページ２００８年１０月１６日　木曜日　午後２時３９分

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 139 140

No comments

Sharp MX-C310 Specifications Page 22