Sharp MZ-1F11 Instruction Manual

SHARP. INTRODUCTION Thank you for bu'y g the MZ-1 E19 SHARP MZ Disk Interface. Before using the MZ Disk Interface, please read this manual c

(1) Stick the provided cable protective sheet on the bottom cover removed when installing the MZ-l Fll to the main unit (see Fig. 10). (2) Inst

* Remove the connector cover from connector CN6 on the rear of the MZ-1 F11 and connect cable CN1 from the data recorder. Data recorder (Fig. 1

C 4. External View and Pin Description of the Connector ) ---------------~--------~ Slot side A I B +5V 1 +5V 02 2 03 01 3 04 DO 4 05 GNO 5 06 (A15

C 5. Specifications ) ~----------~--------------Model: Operating Voltage: Operating Temperature: Operating Humidity: Number of ICs Used: External Dim

SHARP CORPORATION OSAKA, JAPAN Printed in Japan Gedruckt in Japan Imprime au Japon Stampato in Giappone ©1984 SHARP CORPORATION 4J7.5-1-0 TINSE1225A

C _________________ Ca __ ~_o_f_D_i_Sk ________________ ~) 1. Note the precautions printed on the envelope when using disks. 2. Always be sure to i

C 2. Connection ) ~----------------------------Follow the procedures below to connect the MZ-800 personal computer and the MZ disk drive. 1) Removi

2), Mounting the MZ Disk Drive (MZ·1 F11) (1) Remove the 2 screws securing the bottom cover on the lower rear side of the MZ-1 F11. (2) The

(4) Fit the tabs on the front of the louver (accessory) jnto the holes on the MZ-800 cabinet. (5) Connect connector CN2 (coming out from the bott

C~ ____________ 3_._Co_n_n_e_d_i~ __ t_o_th_e_M_Z_._8_00 _____________ ) As explained in the overview, there are 2 ways to connect the MZ-800 and MZ

(4) Insert the connector from the MZ.-1 Fll into the slot. Connect it to the connector on the interface card, and secure with the 2 attached scre

(4) Remove the cover covering slot number 1 or slot number 2 on the expan-sion unit (MZ-1U06) and install the interface card (MZ-1E19). Insert

(7) Connect the connection cable from the expansion unit to the expansion board (MZ-1 E20) installed in the expansion slot of the MZ-800.