Sharp LL-T2010 User's Guide download pdf (Page 86)

- Memory Upgrade Module

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with a minimum of 512 MB of high speed Double Data Rate

Synchronous Dynamic RAM (DDR2-533 SDRAM) factory installed. To increase your notebook’s memory

capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-

line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from

the Fujitsu web store at www.shopfujitsu.com.

Installing Memory Upgrade Modules

1 Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.

2 Make sure that all the connector covers are closed.

3 Turn the notebook bottom side up, and remove the screws from the memory upgrade module compartment.

4 Slide the cover towards the battery compartment slightly, then lift it and remove it (Figure 20).

5 Remove the memory upgrade module from the static guarded sleeve.

6 Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade

module with the connector slot in the compartment.

(Figure 21)

• DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES

SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE.

• THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE (ESD). TO

MINIMIZE RISK TO THE MODULE, OBSERVE THE FOLLOWING PRECAUTIONS:

• BEFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC

ELECTRICITY BUILT UP IN YOUR BODY.

• WHEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY

CONTACTS OR CHIPS. BE CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS;

THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS.

• BE SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES. EVEN IF THE

SYSTEM IS IN HIBERNATE OR STANDBY STATES, DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED

IF POWER IS STILL AVAILABLE TO THE SYSTEM.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 197 198

No comments

Sharp LL-T2010 User's Guide Page 86