Sharp LL-S201A User Manual

LL-S201A Operation Manual (Firmware version 1.700) Target model (December 2013) Touch display LL-S201A

9 Before update, please read the displayed notes. Once notes are read, confirm by clicking the checkbox. "Start" button is disabled unti

10 The progress bar is displayed during the update. If the firmware update is not needed, the program will display the “Finish” screen. Do not

11 Update result are displayed. To exit the program select “Done”, after confirming the LL-S201A is updated to the latest version. Successful upd

12 Error Message Solution Multiple LL-S201A More than one LL-S201A is connected. Connect only one LL-S201A for updating. Confirm only one LL-S201A

13 (2013.12) V1.0 EN13M(2)

1 Index Important information ... 2 Trad

2 This software enables you to update the LL-S201A touch display firmware. •You can update the firmware to the latest version (1.700). •This firmw

3 Hold the flap by the depression on the back of the display and pull the flap up. Check the serial number of the seal affixed to the body of under

4 Update of LL-S201A firmware is possible by using a personal computer with the following conditions. If your personal computer does not meet th

5 USB Cable Connection When updating, a USB cable must be connected between LL-S201A and the computer performing the update. Please make sure to us

6 Expand on the desktop of the computer the compressed file that you downloaded from the Web page. Run the Lls201aUpdateTool under the folder wher

7 "Introduction" screen is displayed when program starts. A brief description of this software is displayed. In case of touch panel user, p

8 This step automatically detects the LL-S201A connected to computer. Results are displayed on screen. Successful detection If detection results