Sharp 13VT-K100 Service Manual download pdf (Page 2)

13VT-K100/150

13VT-CK10

IMPORTANT SERVICE SAFETY PRECAUTION

Service work should be performed only by qualified service technicians who are

thoroughly familiar with all safety checks and servicing guidelines which follow:

SERVICING OF HIGH VOLTAGE SYSTEM

AND PICTURE TUBE

When servicing the high voltage system,

remove the static charge by connecting a

10k ohm resistor in series with an insulated

wire (such as a test probe) between the pic-

ture tube ground and the anode lead. (AC

line cord should be disconnected from AC

outlet.)

1. Note that the picture tube in this receiver employs

integral implosion protection.

2. Replace with tube of the same type number for

continued safety.

3. Do not lift picture tube by the neck.

4. Handle the picture tube only when wearing

shatterproof goggles and after discharging the high

voltage anode completely.

CAUTION: FOR CONTINUED

PROTECTION AGAINST A

RISKOF FIRE, REPLACE

ONLY WITH SAME TYPE 4A-

125V FUSE.

4A 125V

WARNING

1. For continued safety, no modification of any circuit

should be attempted.

2. Disconnect AC power before servicing.

3. Semiconductor heat sinks are potential shock

hazards when the chassis is operating.

4. The chassis in this receiver has two ground systems

which are separated by insulation material. The non-

isolated (hot) ground system is for the B+ voltage

regulator circuit and the horizontal output circuit.The

isolated ground system is for the low B+ DC voltages

and the secondary circuit of the high voltage

transformer.

To prevent electrical shock use an isolation

transformer between the line cord and power

receptacle, when servicing this chassis.

X-RADIATION AND HIGH VOLTAGE LIMITS

1. Be sure all service personnel are aware of the

procedures and instructions covering X-radiation.

The only potential source of X-ray in current solid

state TV receivers is the picture tube. However, the

picture tube does not emit measurable X-Ray

radiation if the high voltage is as specified in the "High

Voltage Check" instructions.

It is only when high voltage is excessive that X-

radiation is capable of penetrating the shell of the

picture tube including the lead in glass material. The

important precaution is to keep the high voltage

below the maximum level specified.

2. It is essential that servicepersonel have available at

all times an accurate high voltage meter.

The calibration of this meter should be checked

periodically.

3. High voltage should always be kept at the rated value

-no higher. Operation at higher voltages may cause

a failure of the picture tube or high voltage circuitry

and;also, under certain conditions, may produce

radiation that exceeds specifications.

4. When the high voltage regulator is operating properly

there is no possibility of an X-radiation problem.

Every time a color chassis is serviced, the

brightness should be tested while monitoring the

high voltage with a meter to be certain that the high

voltage does not exceed the specified value and that

it is regulating correctly.

5. Do not use a picture tube other than that specified

or make unrecommended circuit modifications to the

high voltage circuitry.

6. When trouble shooting and taking test

measurements on a receiver with excessive high

voltage, avoid being unnecessarily close to the

receiver.

Do not operate the receiver longer than is necessary

to locate the cause of excessive voltage.

1 2 3 4 5 6 7 ... 89 90

Comments to this Manuals

No comments

Sharp 13VT-K100 Service Manual Page 2

Comments to this Manuals

Related products and manuals for TVs & monitors Sharp 13VT-K100