Sharp XG-E1200U User Manual download pdf (Page 7)

Extron • System 4

xixi

Switcher Series • User’s Manual • P/N 68-409-02 Rev. C

Configuration and ConnectionsSharp Installation

Page 7

Configuring the Projector

Please refer to your Sharp XG-E1200U Operations Manual to set up your

projector. Also, in order for the System 4xi to know whether the projector is “ON”

or “OFF”, the projector’s 5VDC output jack must be set to “LAMP”.

1. Select MENU.

2. Select SYSTEM SETUP.

3. Select DC 5V OUTPUT.

4. Using the buttons on the rear of the Sharp XG-E1200U, select

LAMP.

▲

6. Plug the 15-pin HD connector of the Projector Communications Extension cable

into the PJ Comm port on the System 4. The other end has a 9-pin female

connector. Plug this into the other 9-pin male D connector on the Sharp COM

adapter.

______ Secure all of the connector screws.

7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) BNC-4 or

5 cable onto the System 4xi output and those on the other end into the

Computer RGB Input port (Input 2) of the projector.

System 4

xixi

xi Series - Sharp XG-E1200U LCD Projector Connections

Use the illustration below as a guide when connecting the System 4xi to a Sharp

XG-E1200U projector. Refer to Sharp documentation to continue the installation.

________ When the Wired Remote jack is installed, the projector’s IR Receivers are

disabled. This jack can be installed or removed at any time. Please perform the

basic projector setup before installing the Wired Remote jack.

____________ In a rack mount, do NOT allow the weight of the cables to be supported by the

System 4

. See page 2-5 for cabling guidelines.

From COM

Adapter

(26-426-01)

Power Plug Adapter

(26-446-01)

To RGBHV source

}

See first

note below

➸

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Sharp XG-E1200U User Manual Page 7

Comments to this Manuals

Related products and manuals for Projectors Sharp XG-E1200U