Sharp XG-E1200U User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Extron • System 4
xixi
xixi
xi
Switcher Series • User’s Manual • P/N 68-409-02 Rev. C
Sharp Installation Configuration and Connections
Page 10
Connecting System 4
xixi
xixi
xi to Sharp NV3
Please follow the steps below to properly install the Sharp NV3 projector.
________ Important note! Some Sharp LCD projector Computer Input ports require an
RGB signal between VGA and XGA rates. You will not be able to install the
System 4LQ
xixi
xixi
xi
with some projector models. Consult your Sharp manual for
maximum input resolution.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Sharp projector. Apply power to the System 4xi and do
the following:
a. Press
to display the MENU SELECT on the LCD screen.
b. Press
or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
yours will show the System 4xi model name, the software version and the
following information:
PRJ = SHARP
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the
System 4
xi
Series User’s Manual
to
remove the System 4xi cover. Then go to page 2-4 and refer to the
configuration below to set up the Main Controller board. Continue with Step 3
(below) when the configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
Sharp NV3 off-on-off-on 0 0 9 F 0 J15 26-467-01
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but not powered on.
________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
5. The Universal Comm Adapter (26-467-01) is a 9-pin D male - 9-pin D female
connector that accommodates the Comm Extension cable.
}
(Note: Information depends on
S
y
stem 4 setu
p
.
)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]
SW1
ON
SW6
SW4
SW3
SW5
J15
3
4
1
2
SW2
Page view 9
1 2 ... 5 6 7 8 9 10 11

Comments to this Manuals

No comments