Sharp JX-9500H Operations Instructions download pdf (Page 53)

Xprint F.A.Q. Document revision 10 (16.09.2008)

Page 53/89

has actually been printed.

Restart rules :

The printer error code "LpdJobAborted" has been introduced in order to draw attention to problems such as

"request rejected", "timeout detected" etc. in dialog with a BSD-LPD. If this error code is displayed, the print job is

entered in the KEEP queue. In addition, message SR00993 is issued if the printer status is queried by means of

/SHOW-SYSTEM-STATUS INF=*REMOTE(...).

The standard restart action belonging to the error code "LpdJobAborted" is an automatic restart after detection

of the error. The system administrator can change this behavior by specifying a new restart rule. The general

action

codes available for this are STOP, SUSPEND and RESTART.

EBCDIC-ASCII character conversion

The BSD-LPD protocol expects data in ASCII code, but BS2000 files contain data in EBCDIC code. RSO has

direct access to the BSD-LPD and therefore carries out this EBCDIC-ASCII conversion itself. It should be borne

in mind that this conversion takes place character by character, i.e. each character is converted independently

of the others. A conversion table can be found in the appendix, page 909.

U2864-J-Z125-12-7600

171 SPOOL

administrator/system administration Configuration of RSO printers

Printing via a SINIX-SPOOL / Xprint BSD-LPD server :

Software configuration

BS2000 BS2000 OSD V1

SPOOL V3.0B

RSO V3.0A

SPSERVE V2.0B

DCM V11.0

UNIX Xprint

Note

All the Xprint commands are described in the syntax of Xprint.

Defining the operating environment :

1. RSO definitions

The target printer must be defined with SPSERVE in RSO:

//ADD-SPOOL-DEVICE DEVICE-NAME=<logical-name>

// DEVICE-TYPE=<printer-type>,

// DEVICE-ACCESS=*TCP-ACCESS(

// INTERNET-ADDRESS=<lpd-internet-addresss>,

// PORT-NAME=<lpd-portnumber>,

// ACCESS-TYPE=*LPD(

// LPD-PRINTER-NAME=<lpd-printername>,

// FROM-PORT-NUMBER=<min. client-portnumber>,

// TO-PORT-NUMBER=<max. client-portnumber>)),

// ...

<lpd-internet-addresss>

The Internet address of the BSD-LPD servers, for XPRINT the Internet address of the host running the

BSD-LPD server. The address is either the IP address in point-decimal notation or the sockect host name

of the the UNIX host as generated via BCAM (in the BS2000 RDF file or the SOCKETHOST address table).

Configuration of RSO printers

<lpd-portnumber>

The port number via which the BSD-LPD server is addressed. In RFC 1179, the value 515 is recommended. In

Xprint,

the same port number must be used, see xpadd -gtw command option -ga. This option has no preset value.

<lpd-printername>

The name of the printer on which RSO should print via the BSD-LPD server. The printer name used in the

configuration

of the BSD-LPD server must be entered. For Xprint, this is any Xprint device name.

<min. client-portnumber>

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 88 89

Comments to this Manuals

No comments

Sharp JX-9500H Operations Instructions Page 53

Comments to this Manuals

Related products and manuals for Print & Scan Sharp JX-9500H