Sharp CD-M4000W Service Manual download pdf (Page 41)

CD-M4000W/CP-M4000

TROUBLESHOOTING

When the CD does not function

When the CD section does not operate when the objective lens of the optical pickup is dirty, this section may not operate. Clean

the objective lens, and check the playback operation. When this section does not operate even after the above step is taken, check

the following items.

Remove the cabinet and follow the trouble shooting instructions..

“Track skipping and/or no TOC (Table Of Contents) may be caused by build up of dust other foreign matter on the laser pickup

lens. Before attempting any adjustment make certain that the lens is clean. If not, clean it as mentioned below.”

Turn off the power, and wipe the lens softly using a cleaning paper moistened with commercially available cleaning solution so

as not to damage it. Be careful not to touch the lens with bare hands.

Dust gradually accumulates on the objective lens during use, and it may degrade performance. To avoid this problem, use a

cleaning disc designed for CD optical pickup lenses..

Parts code

CD optical pickup Lens cleaner disc

UDSKA0004AFZZ

Using the brush in the cleaner cap, apply

or 2 drops of

th:e

cleaning fluid to the

brush on the CD cleaner disc which has the mark next to it.

2. Place the CD cleaner disc onto the CD disc tray with the brush side down,then

press the play button.

Cleaning fluid

3. You will hear music for about 20 seconds and the CD player will automatically stop.

If it continuous to turn, press the stop button.

The CD lens cleaner should be effective for

30-50

operations, however if the

brushes become worn out earlier then please the cleaner disc.

If the CD cleaner brushes become very wet then wipe off any excess fluid with a soft

cloth.

Do not drink the cleaner fluid or allow it to come in contact with the eyes. In the

event of this happening then drink and/or rinse with clean water and seek medical

advice.

The CD cleaner disc must not be used on car CD players or on computer CD-ROM

drives.

Cleaner disc

is prohibited by law.

When a CD cannot be played

“E-CD01

”

is displayed.

(1) Check the power to

ICI

(LC78645E),

the presence of the clock signal (33.8688 MHz) and the status of the RESET terminal

(pin 66 on ICI).

(2) Does the pickup move to the PICKUP-IN Switch (SW4) position?

If (1) and (2) are OK, check the system microcomputer (especially the communication line with the DSP).

2. Pressing the CD operation key is accepted, but playback does not occur.

(1) Focus-HF system check

(2) Tracking system check

(3) Spin system check

(4) PLL system check

(5) Others

-4l-

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 53 54

Comments to this Manuals

No comments

Sharp CD-M4000W Service Manual Page 41

Comments to this Manuals

Related products and manuals for Cassette players Sharp CD-M4000W