Sharp CD-BA200 Service Manual download pdf (Page 5)

– 5 –

CD-BA200

OPERATION MANUAL

RESETTING THE MICROCOMPUTER

Reset the microcomputer under the following conditions:

To erase all of the stored memory contents (clock and timer

settings, and tuner and CD presets).

If the display is not correct.

If the operation is not correct.

Press the ON/STAND-BY button to enter the stand-by mode.

While pressing down the button and the X-BASS/DEMO

button, hold down the ON/STAND-BY button for at least 1

second.

"CLEAR AL" will appear.

Caution:

The operation explained above will erase all data stored in

memory including clock and timer settings, and tuner and CD

presets.

X-BASS/

DEMO

POWER

ON/

STAND-BY

SETTING THE CLOCK

POWER

ON/

STAND-BY

CLOCK

MEMORY/SET

TUNING/

TIME

( )

AM 12:00 AM 0:00 0:00

In this example, the clock is set for the 12-hour (AM 12:00) sys-

tem.

Press the ON/STAND-BY button to enter the stand-by mode.

Press the CLOCK button.

Within 5 seconds, press the MEMORY/SET button.

Press the TUNING/TIME ( or ) button to select the time

display mode.

"AM 12:00" → The 12-hour display will appear.

(AM 12:00 - PM 11:59)

"AM 0:00" → The 12-hour display will appear.

(AM 0:00 - PM 11:59)

"0:00" → The 24-hour display will appear.

(0:00 - 23:59)

Note that this can only be set when the unit is first installed

or it has been reset.

Press the MEMORY/SET button.

Press the TUNING/TIME ( or ) button to adjust the hour.

Press the TUNING/TIME ( or ) button once to advance

the time by 1 hour. Hold it down to advance continuously.

When the 12-hour display is selected, "AM" will change auto-

matically to "PM".

Press the MEMORY/SET button.

Press the TUNING/TIME ( or ) button to adjust the

minutes.

Press the TUNING/TIME ( or ) button once to advance

the time by 1 minute. Hold it down to change the time in 5

minute intervals.

The hour setting will not advance even if minutes advance from

"59" to "00".

Press the MEMORY/SET button.

The clock starts operating from "0" second.

(Seconds are not displayed.)

And then the clock display will disappear after a few seconds.

To see the time display:

Press the CLOCK button.

The time display will appear for about 5 seconds.

Note:

The clock display will flash on and off at the push of the CLOCK

button when the AC power supply is restored after a power

failure occurs or after the AC power cord is disconnected.

If this happens, follow the procedure below to change the clock

time.

To change the clock time:

Press the CLOCK button.

Within 5 seconds, press the MEMORY/SET button.

Perform steps 6 - 9 above.

To change the time display mode:

Perform steps 1 - 2 in the section "RESETTING THE

MICROCOMPUTER", on page 15.

Perform steps 1 - 9 above.

(Main unit operation)

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments

Sharp CD-BA200 Service Manual Page 5

Comments to this Manuals

Related products and manuals for Cassette players Sharp CD-BA200