Sharp VL-MC500U Service Manual download pdf (Page 23)

VL-MC500U/K

9-6. Removing the cassette

(1) Apply DC3V to the loading motor unload slightly.

(2) After the tape is slackened, turn the rotor (lower side of mechanism)

of capstan motor to tighten the tape. (Arrow direction, Fig. 1)

(3) Repeat the operations (1) and (2). After the pole base has been

completely unloaded, ascertain that the tape is not loose.

(4) Finally apply again DC3V to the loading motor, so that the cassette

controller ejects.

(5) Take out the cassette.

Note) DC3V is applied to the loading motor as shown Fig 1. Then, the

mechanism moves in the unloading direction.

From rear

surface side

From rear

surface side

Main cam

Loading lever

Intermediate gear angle

S loading arm

Tu loading arm

Pinch control lever

T arm control lever

: Oiling(Cosmo Hydro HV22)

: Greasing(Moly Coat YM-103)

Enabled after

assembling

Enabled after

assembling

Enabled after

assembling

Pinch lever

: Oiling

: Greasing

Brake shifter

Slide adjustment angle

Side of the main chassis

Side of the slide chassis

Swing arm

Plus pole

GREASE/OIL APPLICATION

Capstan FPC stopper

Rear surface · groove

side surface

Front surface · rear

surface · groove

side surface

Drum base assembly

Part A

Fig. 1

Capstan motor rotor rotation direction

(from rear side of mechanism)

Loading motor

Minus pole

Sensor FPC wiring

After joining the main chassis

and slide chassis

Including groove

side surface

(Applied)

Sensor FPC

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

Comments to this Manuals

No comments

Sharp VL-MC500U Service Manual Page 23

Comments to this Manuals

Related products and manuals for Camcorders Sharp VL-MC500U