Sharp HT-SB602 Specifications download pdf (Page 18)

E-17

Operating the TV with the remote

control

You can operate Sharp TVs with this system’s remote

control.

 Watching TV

Point the remote control at the TV.

1 Press the TV ( ) ON/STANDBY button to turn

on the TV.

2 Pressing the TV CH + or – button enables TV

channel switching.

3 Press the TV VOL + or – button to adjust the TV

volume.

Other operable button

Input Select Button

Mute (TV)

AV mode

Troubleshooting chart

Many potential problems can be resolved by the owner without

calling a service technician.

If something is wrong with this product, check the following

before calling your authorized SHARP dealer or service centre.

 General

Symptom Possible cause



No sound is heard.



Is the input signal (selection) set

properly?



Is the volume level set to “MIN”?



Is muting activated?



Is HDMI compliant equipment

being used?



Is the HDMI cable connected

correctly?

Connect the HDMI cable correctly

and then perform the reset

procedure. (refer page 18)



Do not connect or disconnect

an HDMI cable whilst power is

on. This may lead to operation

problems.



The sound from

subwoofer is not

well balanced.



Is the subwoofer level set to the

minimum or maximum level?



Power turns off

suddenly.



Is the HDMI cable connected

correctly? Connect the HDMI

cable correctly and then perform

the reset procedure.



Noise is heard

during playback.



Move the speaker away from any

computers or mobile phones.



When a button

is pressed, the

sound bar does not

respond.



Set the sound bar to the standby

mode and then turn it back on.



The power is not

turned on.



Is the sound bar unplugged?



The protection circuit may be

activated. Unplug and plug in the

power lead again after 5 minutes

or more.



3D images not

displayed on the

TV.



Depending on the TV and Video

component, 3D images may not

be displayed.

Check the operation manual of the

respective component.



HDMI cable not support 3D image.



Background noise

appears when

connecting with

RCA audio output

terminal connection

from a TV-set/

DVD/Blu-ray Disc

Player.



Please change to HDMI/ARC or

headphone terminal from TV-Set/

DVD/Blu-ray Disc Player. This

effect may occur depending on

TV/DVD/Blu-ray Disc Player-

Brand, model and age, and it is

not the sound bar problem.



Wireless

connection cannot

be established.



Check the distance between the

sound bar and subwoofer (less

than 10m (32 feet)).



Make sure there is no other

wireless devices near the unit.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Sharp HT-SB602 Specifications Page 18

Comments to this Manuals

Related products and manuals for Blu-Ray players Sharp HT-SB602