Sharp XL-3000 Service Manual download pdf (Page 5)

– 5 –

XL-3000/3000C

OPERATION MANUAL

Setting the Clock

This may be operated only with the remote control.

In this example, the clock is set for the 12-hour (AM 12:00) display.

To confirm the time display when the power is on:

Press the CLOCK button.

The time display will appear for about 5 seconds.

Note:

The time will flash at the push of the CLOCK button when the AC

power supply is restored after a power failure or unplugging the unit.

Readjust the clock as follows.

To readjust the clock:

Perform "Setting the Clock" from the beginning.

To change the 12-hour or 24-hour display:

Press the CLOCK button and within 3 seconds, press

the MEMORY button.

Within 1 minute, press the PRESET ( or ) button to

select 12-hour or 24-hour display and then press the

MEMORY button.

"AM 12:00" The 12-hour display will appear.

(AM 12:00 - PM 11:59)

"0:00" The 24-hour display will appear.

(0:00 - 23:59)

Note that this can only be set when the unit is first installed or it

has been reset.

Within 1 minute, press the PRESET ( or ) button to

adjust the hour and then press the MEMORY button.

●

When the 12-hour display is selected, "AM" will change au-

tomatically to "PM".

Within 1 minute, press the PRESET ( or ) button to

adjust the minutes and then press the MEMORY button.

●

The hour will not advance even if minutes advance from "59"

to "00".

●

The clock starts from "0" second. (Seconds are not dis-

played.)

1 Clear all the programmed contents.

2 Perform "Setting the Clock" from the beginning.

Remote Control

■

Test of the remote control

Check the remote control after checking all connections have been

correctly.

Face the remote control directly to the remote sensor on the unit.

The remote control can be used within the range shown below:

Press the POWER button. Does the power turn on? Now, you can

enjoy the music.

Remote sensor

8" - 20'

(0.2 m - 6 m )

Troubleshooting Chart

■

If trouble occurs

When this product is subjected to strong external interference

(mechanical shock, excessive static electricity, abnormal supply

voltage due to lightning, etc.) or if it is operated incorrectly, it may

malfunction.

If such a problem occurs, do the following:

Caution:

This operation will erase all data stored in memory including clock,

timer settings, tuner preset, and CD program.

1 Set the unit to the stand-by mode and turn the power on

again.

2 If the unit is not restored in step 1, unplug and plug in the

unit, and then turn the power on.

3 If neither step 1 nor 2 restores the unit, do the following:

Press the POWER button to enter the power stand-by mode.

Unplug the AC power cord from the AC INPUT jack on the

unit.

While pressing down the MEMORY/SET button and the

button, plug the AC power cord into the AC INPUT jack on the

unit.

AC INPUT

1 2 3 4 5 6 7 8 9 10 ... 63 64

Comments to this Manuals

No comments

Sharp XL-3000 Service Manual Page 5

Comments to this Manuals