Sharp VC-488NS Service Manual download pdf (Page 29)

Installation

Detailed Installation procedure

Installing the Surge Protection

Install the lightning arrestor on the mast as shown in Figure 2-3. Install

the Surge Protector device and the grounding cable on the backside of

the rack – as shown below. Tighten well using M8 screw.

Figure 2-6: Installation of Lightening Arrestor on Mast

Connecting the N-type to TNC adaptor

Connect the TNC to N-type adaptor (part of the kit) on the “surge” side –

if the lightning arrestor has N-type connectors. If not the cable should

be connected directly without any adaptor.

GPS Timing Receiver Installation and Operation Manual

2-11

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

No comments

Sharp VC-488NS Service Manual Page 29