AF-S80EXAF-R80EXROOM AIR CONDITIONERINSTALLATION AND OPERATION MANUALPAGECONTENTSThis INSTALLATION AND OPERATIONMANUAL explains th
10PARTS NAMESUNITCONTROL PANEL Front Cabinet Air Inlet (Indoor Side) Horizontal Louvers Vertical Louvers Air Outlet (Indoor Side) Control Panel Rear
11HOW TO OPERATECooling operation with high fan speed.Cooling operation with medium fan speed.Cooling operation with low fan speed.Fan only operation
12HOW TO OPERATE---Lower temp.Touch the TEMPERATURE settingpad to adjust the temperature set-ting.• Temperature can be set within the rangeof 64°F to
13HOW TO OPERATEENERGY SAVER OPERATIONDuring normal operation, the thermostat automatically controls cooling and the fan runs continu-ously. When the
14HOW TO OPERATEON TIMER OPERATION(If you wish to start the operation6 hours and 30 minutes later, setthe delay time as shown above.)1Touch the TIMER
15HOW TO OPERATEOFF TIMER OPERATION• This unit has a built-in timer that can be programmed to shut the unit off up to 12 hours in advance.You can set
16HOW TO OPERATEINSTALLING BATTERIESUse two size-AA (R6) batteries.Battery compartment coverNOTES:• The battery life is approximately one year with no
17HOW TO OPERATE• The time setting will change as you push the button. The displaywill change as follows;TEMP.TEMP.---Raise temp. setting 1°F at a ti
18CLEANING AND MAINTENANCECLEANING THE FILTERIf the filter is clogged with dust, the amount of air flow willbe reduced, resulting in poor cooling perf
19BEFORE CALLING FOR SERVlCEIF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECKTHE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE.AIR CONDITIO
2To aid in answering questions if you call for service or for reporting loss or theft, please recordbelow the model and serial number located on the r
SHARP ELECTRONICS CORPORATIONSharp Plaza, Mahwah, New Jersey 07430-2135SHARP CORPORATIONOsaka, JapanPrinted in Thailand
3SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"),when shipped in its o
4INSTALLATION INSTRUCTIONSBefore beginning installation, read these instructions carefully.Use the enclosed MOUNTING KIT for proper installation.The m
5ACCESSORIESNo.Accessories Q'tyRight closure assembly 1Left closure assembly 1Window sash foam seal 11. Screw driver (medium size Phillips)2.
6Insert the right closure assembly and theleft closure assembly into the top angleand the bottom channels.Secure the right and left closure to
778Secure the top angle of the unit and thetop of the closure assemblies to the sashwith three of the provided screws. (L=1",25.4mm)And secur
8IMPORTANT: Points to keep in mind when using your air conditioner.• Install the air conditioner by following the installation instructions given in t
9PRECAUTIONS•Allow 3 minutes for the compressor to restart cooling.If you turn the air conditioner off and immediately restart it, allow three minutes
Comments to this Manuals