Sharp FU-40SE-K Specifications

RFU-40SE-KTabletop / wall-mounting typeAIR PURIFIEROPERATION MANUAL

PREPARATIONBe sure to remove the power plug from the wall outlet.INSTALLING THE FILTERSTo maintain the quality of the filters, they are installed in

2Install the filter1Remove the HEPA filter fromthe polyvinyl bag and install itin the main unit with the display facing up.Insert so that the tabs on

OPERATIONMAIN UNIT OPERATIONThe unit will start operation when the MODE-ON/OFF button is pressed.(The unit will start operation in AUTO mode)• During

REMOTE CONTROLOPERATION•To start operation, press the ON/OFF button.A short beep will sound and operation will start in theAUTO mode.•To stop operatio

CARE AND MAINTENANCE(To maintain the best performance of this product, please clean the unit periodically.)When cleaning, be sure to remove the power

Guide for filter replacing timing• The following is a guide from JEM 1467 by Japan Electrical Manufacturers Association inJapan, and in JEM 1467, the

TROUBLESHOOTINGBefore calling for repair, check the symptoms below for possible remedies, since the problem maynot be a malfunction of the unit.SYMPTO

FEATURESCluster Ion ControlThe unit controls the ratio of minus clusterions and plus cluster ions depending onthe condition of the room.• Clean modeAp

• Do not use the unit if the power cord or plug is damaged or the connection to the walloutlet is loose.Electrical shock, short circuit and/or fire ma

CAUTIONS CONCERNING THE USAGE OF THIS PRODUCT• Do not block the intake and exhaust ports.• Do not use the unit near or on hot objects, such as a stove

PlasmaclusterNAMES OF PARTSMAIN UNIT DISPLAYFilter timer lampAUTO operation lampFan level lamps*Tobacco smoke mode operation lampPollen mode operation

ACCESSORIESRemote control(1 unit)Battery(AA battery X2 units)When used on a tabletopStand(1 unit)Thumbscrew(2 units)Located onbottom ofstandCLUSTER IO

INSTALLATIONWHEN USING THE UNIT ON ATABLETOPFIXING THE STAND1Remove the front panel.• At this time, also remove the pre-filter,stamina-power carbon an

Mount the bracket to the back of the main unitusing the small screws included.3Place the cushions as shown4Mount the main unit(1) Align the horizontal