Sharp XG-MB70X Specifications Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
SmartPanel Projector Driver Application Note
Sharp XG-MB70X
© 2004 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
II. CONTROL WIRING
PROJECTOR CONTROL
RS232 IR/SERIAL
RX
GND
CTS
RTS
TX
+12V
GND
IR/SER
SENSE
Female DB9
RS-232 to
RS-232C
1/8" Mini
Female
IR Emitter to
any window
Sharp Male DB9 to Male MiniDIN adaptor
(included with Sharp projector, labeled RS-232C)
54321
987
6
5432 1
IR Emitter
(included with Panel)
TX to 2
RX to 3
GND to 5
This section describes how RS-232 and the Infrared
Emitter must be wired to the Sharp projector.
A. RS-232 should be connected to the Sharp control port
labeled RS-232C. Connection should be as follows:
1. Wire the Panel to a female DB9 as follows:
TX to 2
RX to 3
GND to 5
2. Connect this female DB9 to the Sharp’s custom DB9 to
mini-DIN adapter cable. This cable is included with the
Sharp and is labeled RS-232C.
3. Connect the Sharp custom cable to the projector port
labeled RS-232C IOIOI.
B. Infrared should be wired to any Sharp infrared port.
Connection should be as follows:
1. Wire the Panel to a female 1/8" Mini as shown; wire
IR/SER to tip and GND to ring. Direct wiring to the IR
Emitter is not recommended as it makes removal of the
Panel for service more difficult.
2. Attach to any projector IR port using the Panel’s IR
Emitter (included with the Panel).
Note that the emitter glows red when IR is emitted so wiring
can be verified.
SPECIAL CONTROL NOTE
The following projector menu settings must be correctly set
to control the Sharp XG-MB70X with the SmartPanel:
In the projector menu OPTIONS1 the ECONOMY
MODE must be set to OFF. Be sure the arrow is
pointing to the RIGHT.
In the projector menu OPTIONS 2 the setting
RS232C must be set to 9600 (default).
In the projector menu OPTIONS 2 the setting
LAN/RS232C must be set to ENABLE (default).
Questions should be directed to SP Controls
technical support at [email protected].
Page view 3
1 2 3 4 5 6

Comments to this Manuals

No comments