Sharp R-508FS User's Guide Page 211

  • Download
  • Add to my manuals
  • Print
  • Page
    / 307
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 210
bizhub C652/C652DS/C552/C552DS/C452 8-4
8.1 Paper
8
Loading paper into trays 3 and 4
The same procedures can be used to load paper into trays 3 and 4.
The following procedure describes how to load paper into tray 3.
1 Pull out tray 3.
NOTICE
Be careful not to touch the surface of the paper take-up roller with
your hand.
2 Lift up the paper take-up roller, and then load the paper into the
tray.
% Load the paper into the tray so that the side of the paper to be
printed on (the side facing up when the package was
unwrapped) faces up.
% Do not load so many sheets of paper that the top of the stack
is higher than the mark.
% Do not load tray 3 with paper of a size other than that
previously specified.
% If paper is curled, flatten it before loading it.
% If special paper is loaded, the paper type must be specified.
% Load letterhead paper so that the side to be printed on faces down.
% To change the paper size for tray 3, contact your service representative.
3 Lower the paper take-up roller, and then close tray 3.
d Reference
To configure paper settings:
Press [Basic] ö [Paper].
Page view 210
1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 306 307

Comments to this Manuals

No comments