Sharp AL-2051 Service Manual download pdf (Page 29)

AL-2051 UNPACKING AND INSTALLATION 5 - 12

5) Attach the Optical right hole mylar B at the 2 positions shown in

the diagrams below which are at the top of the rear side of the

main unit.

Note: The holes should be covered with the mylar.

Attach along the edge of the cushion (the yellow line in the dia-

gram below).

Align with the inside line of the bent part (the yellow line in the

diagram below).

Align with the raised part (the yellow line in the diagram below).

Match the center of the mylar (in the horizontal direction) to the

center of the raised part.

6) Attach the Scanner motor metal plate cushion at 1 position on

the attachment plate of the motor on the rear side of the main

unit.

Note: The hole on the top of the motor unit should be covered

with the mylar.

Align the edge of the metal plate and the edge of the cushion

(the yellow line in the diagram below).

7) Attach the Scanner upper surface cushion on the top and the

rear side at the rear side of the main unit.

Align the cushion with the side of the raised part (the yellow line

in the diagram below).

Bend the part which is sticking out to the rear side of the scan-

ner and attach to the surface.

Press the cushion at the steps shown in the diagram so that

there will be no gap.

Press the cushion to make sure all the holes are covered.

Stick the excessive part on the side.

Press and attach the cushion aligning it to the metal plate so

that there will be no gap between them.

20mm - 25mm

Do not cover this hole. Align the edge of the cushion with

the edge of the metal plate.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 138 139

No comments

Sharp AL-2051 Service Manual Page 29