Sharp Projector Remote Control User Manual download pdf (Page 12)

Setting up and Displaying the Mobile Workstations in

Room 111- Step-by-Step

Instructions for using the Room 111 mounted projectors to display images and output sound from

the Lab's PC and Mac mobile workstations.

0.0 Initial setup

0.1 Move computer into 111 with the following items on the cart or in the

cart's basket. Each mobile workstation has its own set of labeled

cables for 111.

• 2 beige extension cables: 1 attached to the cpu (adapter needed

for Mac) --1 attached to the monitor cable. These extensions

should remain connected to the cpu and the monitor cable since they

allow more flexibility in positioning the workstation. These cables can

also be used with the mobile projectors.

• A split, dark gray cable with one end that connects to the wall

jack, and, a) a short length that connects to the extension leading

to the monitor cable, and b) a longer length that connects to the

extension leading to the cpu. This cable is only used in 111.

• A thin, black cable that connects the wall jack speaker port with

the speaker port on the cpu. This cable is only used in 111.

0.2 See Figure A

Two wall jacks are beneath the white board near the podium; one

labeled CPU 1, the other CPU 2. These are the jacks to connect the

projectors to the computers using the split, dark gray cable. Either jack

may be used.

To their right of are two jacks labeled 101D1 and 101D2. These jacks

are for connecting the computers to the network (including Internet

access) via network cables and either may be used, no matter whether

CPU 1 OR CPU 2 is used.

Plug the computer's power cord into the wall outlet to the right of the

101D1 and 101D2 jacks.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

No comments

Sharp Projector Remote Control User Manual Page 12