Sharp XE-A303 Instruction Manual download pdf

To ensure the cash register operates properly, initialise it using the following

procedure.

• Make sure the power cord is not inserted into the AC outlet.

• Insert the manager (MA) key into the mode lock and turn it to the PGM position.

• While holding down both the key and the key, insert the plug into the AC outlet.

The buzzer will sound three times and "***MRS.***" will be displayed.

• The cash register has now been initialised.

The register display will show "0.00" with "PGM".

CAUTION: To charge the rechargeable batteries, keep the power on for one or two days.

Leave the register with the mode switch in a position other than .

NOTE: If you press a key by mistake, an error message may be displayed. Press the key to

clear the message after installing paper rolls.

Model XE-A303

Installing The Cash Register

Install the cash register using the fixing

angle bracket provided with the register.

• Thoroughly clean the location where the

fixing angle bracket (B) is to be placed.

• Peel off the adhesive tape on the fixing

angle bracket.

• Hook the angle bracket onto the hook

(A) that is located at the bottom rear

of the register.

• Firmly stick the fixing angle bracket to the

table surface that you cleaned above.

To remove the resister from the fixing

angle bracket:

• Lift up the front of the register and pull

the register towards you.

Important Notice

The cash register will

operate correctly only

after the following steps

have been carried out.

For quick set-up, follow the steps shown below. Note that malfunction may occur

if you do not follow the steps. For further information, please read the instruction

manual. For installing the cash register, find a stable surface near an AC outlet

where the cash register will not subject to water sources or direct sunlight.

PGM

MGROPX/Z

REG

X2/Z2

X1/Z1

Mode Lock

Initialising the Cash Register

PGM

MGROPX/Z

REG

X2/Z2

X1/Z1

Mode Lock

JOURNAL

Preparing the Printer

• Lift the rear of the printer cover and detach it.

• Remove the white retainer at the position

shown at the right.

NOTE: Please keep this retainer for future

use when transferring the cash register.

• Move the print head release lever upwards

as illustrated at the right.

PGM

MGROPX/Z

REG

X2/Z2

X1/Z1

Mode Lock

1 2 3 4

Summary of Contents

Page 1 - Model XE-A303

To ensure the cash register operates properly, initialise it using the following procedure.• Make sure the power cord is not inserted into the AC out

Page 2 - Setting the Date and Time

1.2.• Cut off approximately one revolution of each paper roll. Make sure the paper end is cut as illustrated below. For receipt paper installatio

Page 3 - Programming A Receipt Message

PGMMGROPX/ZREGX2/Z2X1/Z1Mode LockEntering A Basic SaleInsert the operator key into the mode lock and turn to the REG position.The cash register has fo

Page 4 - Common Error Messages

TL/NSTL/NSPGMMGROPX/ZREGX2/Z2X1/Z1Mode LockReporting10The cash register has two reporting types. Use the reading function (X) when you need to take a

Sharp XE-A303 Instruction Manual

Browse online or download Instruction Manual for Cash registers Sharp XE-A303. Sharp XE-A303 Instruction manual User Manual

Summary of Contents

More documents for Cash registers Sharp XE-A303

Comments to this Manuals

Sharp XE-A303 Instruction Manual

Browse online or download Instruction Manual for Cash registers Sharp XE-A303. Sharp XE-A303 Instruction manual User Manual

Summary of Contents

More documents for Cash registers Sharp XE-A303

Comments to this Manuals

Related products and manuals for Cash registers Sharp XE-A303